This is a 3D-printed reproduction of the rare and discontinued manual transmission shifter bezel for the Toyota Soarer.  It has been recreated from a 3D scan for perfect fitment within the factory center console trim with all of the same accents and curvature of the original bezel.  This reproduction bezel also utilizes metal clips to keep it fastened to the console trim for easy installation and removal without risk of breakage, and has a simple modular boot attachment using zip ties should you ever need to adjust, remove, or replace it. This bezel will come pre-assembled with metal attachment clips and a polyurethane leather shift boot for a quick and easy install. 

*Please note, this is a reproduction of the bezel for factory manual Toyota Soarers with the 5-speed R154 transmission; I CANNOT guarantee it will fit with any other transmission-swapped Soarer.  For your reference, see the picture in the listing indicating the center position of the “bore” in the bezel where the boot is located and ensure this roughly matches the location of the shifter in your car.

• 1991-2000 Toyota Soarer, may fit swaps

• For RIGHT-HAND DRIVE CARS ONLY

• Replaces Toyota #58805-24060 / 24070

* As stated previously, PLEASE see the picture indicating the rough center position for the shift boot and ensure this closely matches the location of the shifter in your car.

• Main bezel piece is printed with black filament

• Included shift boot is made of textured black leather 

• Bezel can be optioned to come with or without the cutout for the ashtray “latch” – choose ‘Yes’ if you are retaining the factory ashtray and need this space, or ‘No’ if you have replaced or modified the ashtray and do not want this open space.

• Remove entire center console trim piece and ashtray, then press out metal clips holding OEM bezel in place

• Re-assemble ashtray onto center console trim and re-install both in your car

• Line up the new bezel with the cutout in the console trim, tuck the excess boot material under it, and press it straight down into place, ensuring the metal clips are lined up with their respective slots and firmly attached

• Slide boot down over shifter and re-install shift knob

• If the chrome ring on the included shift boot is too narrow, you will need to flip the boot to be inside-out and snip the small zip tie keeping it attached

• New / replacement boot can be installed by removing bezel assembly, snipping the existing zip ties, tucking the new boot over the inside lip, and tightening down 4 new zip ties

• ASA plastic for main bezel piece to provide stiffness and heat resistance

• Polyurethane leather shift boot with removeable chrome-plated ABS plastic ring

• Alloy steel attachment clips 

• Due to the nature of 3D-printed parts, some small surface flaws and layer lines will be visible in the final product

• I have done my best to optimize the fit and finish of the final printed parts and will conduct a quality and fitment check before shipping

• However, please understand that these parts will not be 100% perfect in comparison to those made through injection molding by an OEM

• 5-7 days for processing, printing, and shipping

• Domestic shipping in the USA via USPS Ground Advantage

• International buyers are responsible for any and all shipping, customs, and import fees

• Must be initiated within 30 days of receipt for UNUSED and UNDAMAGED parts only