Specification:
- 11x4.00-5”
- Tire diameter: 11"
- Tire width: 4”
- Rim Diameter: 6"
- Bushing Size: 3/4" or 5/8"
- Hub Length: 3.4"-4"-4.5"-5" Centered Hub
- Fits many zero-turn mowers
- 300 lbs load capacity. Not for highway use.
NOTE:
Please check your existing tire sidewall for tire, hub, and bearing size to ensure proper replacement fit.
|
|
|
|
|---|---|---|
|
Tire Diameter
Tire Width
|
Bushing -Measure inside diameter of the opening
NOTE: Please carefully confirm the bearing size before installation. |
Hub Length -Through the center of the hub
|
Fits many zero-turn lawnmowers
This lawn mower tire is widely used on wheelbarrows, garden carts, hand trucks, pressure washers, generators, air compressors, lawn mowers and other types of outdoor power equipment
How To Change Tire Bearings
You Will Need:
Hammer, Screwdriver
Block of Wood,
Replacement Bearings
Step One: Prop the tire up to allow room for the bearings to be removed from the hub.
Step Two: Place the screwdriver through the bearing hole until it hits the backside of the bearing on the opposite side.
Step Three: Hit the top of the screwdriver with a hammer until the bearing pops out into the bucket below.
Step Four: To reinstall bearings, rest the new bearing on the opening in the hub and place the block of wood on top of the bearing to avoid hitting the bearing directly.
Step Five: Hammer directly onto the block of wood to get the bearing in the hub.
Note:
If the bearing drops freely into the hub prior to hitting with a hammer, remove the bearings and tap gently along the edge of the hub to create a tighter fit for the bearing.
