EASY TO USE !
Follow these steps and enjoy your wonderful crafting!
- 1. Insert the glue stick.
- 2. Press and hold the switch for 2 seconds. Red light and green light shine at the same time.
- 3. After 1 minute, the red light will change to green. The equipment is ready.
- 4. Pull the joystick to start. (It is forbidden to remove the remaining glue sticks during use.)
- 5. Press and hold the switch for 2 seconds to turn it off. (In the process of crafting, the glue gun will automatically turn off in 10 minutes of inactivity to protect the safety of the user.)
- 6. The red light is on when charging; the green light is on when fully charged. The red light is on when there is no electricity. The red light flashes 3 times and then goes out.
Attention:
- 1. The product uses a charger with output voltage of 5V and current of 1-2A, so it requires the voltage and current to meet the needs and if the actual voltage and current are lower than this standard, it will spend more hours charging.
- 2. Do not remove the remaining glue sticks or pull out the unused glue stick during use , it will damage the glue gun. Besides, the glue stick can be only be replaced after the glue gun is power off.
- 3. When the glue stick is not long enough to advance, you need to add a new glue stick.
- 4. Remember to turn off the power when not in use.
- 5. When the glue gun needs to be placed during work, first put down the bracket and then stand it on a flat surface.
- 6. Do not directly touch the nozzle and hot glue during use to avoid scalding.
|
|
|
|
|---|---|---|
Automatic Power-Off SystemWith upgraded technology, we add a intelligent safety system for hot glue gun, so it will power off automatically after 10 minutes of inactivity to protect the safety of the user and save energy simultaneously. In the the process of crafting, if it automatically shuts down in 10 minutes of inactivity ,it is normal and you just need to turn on again.
Easy To Use
WARM TIPS: - Do not touch the nozzle and hot glue directly during on using to avoid scalding. - When the glue stick is not long enough to advance, you need to add a new glue stick. - It not supported to be used while charging. This is lithium ion wireless cordless hot glue gun, please use it after unplugging the charge cable line. - Do not remove the remaining glue sticks or pull out the unused glue stick during use , it will damage the glue gun. Besides, the glue stick can only be replaced after the glue gun is power off. - If there's glue drips before pull the trigger, NOTE : it's not leaks. because put in glue stick may squeeze the glue residue from last use, As we recommend, please insert the glue stick before heating. Or do not push the glue stick too tight after heating. Simply place a piece of paper under the nozzle also can be a good way to prevent drips. - If there's no glue out after heat, it may because the preheating time is insufficient or the switch status is wrong. If the gun body does not heat up after preheating, the heating element is malfunctioning. In addition, if it is not used for a long time when the power is on, it will also cause the glue stick to carbonize (scorch) and block the gun nozzle, It can be used normally by dredging with thin iron wire or fine needle. |
Long Standby TimeCompared to lots of glue guns with cords, our hot glue gun kit is more convenient, it uses a charger with an output voltage of 5V and current of 1-2A and is equipped with an upgraded 2200mAh premium lithium-ion battery, so it only takes 2 hours to fully charge and can work for up to 100 minutes.
|
|
