Pre-Cut synthetic leather with a self adhesive back for the Yashica FR II camera.

Leatherette thickness of 0.7mm or approximately 27mil.

If you do NOT want the four holes cut into the back covering because you are not re-attaching the memo holder please put comments in at checkout or contact me.

Before applying - it is very important to remove the old glue / adhesive completely. You CANNOT put this on top of the old glue.

Tips to help with old leatherette and glue removal:

- Heat up the old leatherette a bit using a hair dryer - more of the glue will stay on the old leatherette.

- Use nail polish remover (non-acetone) and a rag and/or q-tips to help scrape off the old glue.

- Patience - sometimes (not always) it will take some time - but it can't be stressed enough how important it is to get the old glue off.

Application tips:

- Make sure everything is at room temperature.

- Removing buttons, levers or memo holders may be needed for proper application.

- One trick you can use is to spread a drop or two of hand sanitizer on the adhesive side - this will allow you to position the leatherette more easily - once the sanitizer evaporates the adhesive gets sticky again.

- Tweezers or something else small will help to push it into the small nooks and crannys.

- Occasionally on tight bends, you may need to add a drop of glue to ensure solid adhesion.

- Once you're sure of the positioning press firmly to get the best adhesion - you may need to keep it pressed down for a minute while you wait for the hand sanitizer to evaporate.

- Please let the camera sit for a couple days after finished - this helps everything to set.

Feel free to contact me if you have any questions or concerns.

Thanks for looking