(This item is 220V, do not support 110V)

Features And Performance:

Lever Punch Tyre Vulcanizing Machine, Tyre Repair Tool Equipment Cars Spares, The temperature can be changed automatically according to different conditions.It adopts press lead screw tightly. It is really a economical, durable and practical machine, It features galvanic signal indication, short circuit protection, 120 minutes working time setting or always working setting optionally. Be suitable for various type inner tubes, car outer tube, and tubeless tires. It is nice Tire Repair Kit.

Description:

Simple, one-man operation

Repairs tread, shoulder and sidewall

Large-capacity, fully rotating C-frame accommodates different wheel sizes and allows for vertical or horizontal repairs

Vulcanizing repair process cures the patch and inner tire lining to form a dense, sealed repair job

An adjustable, swing-open, rotating C-frame cavity simplifies tire loading and unloading while maximizing stability

Adjustable height tower

Contoured inner and outer curing heads conform to a variety of tire profiles

Long-life Acme thread hand-wheel screw applies over 4,000-lbs. of pressure and heat for maximum adhesion of patch to casing

Energy and cost efficient for lower operating costs

Lightweight, self-standing design offers portability and maximum stability

Doesn't require any time consuming tensioning straps

Handles long sidewall repairs

Cures both patch and plug at the same time

Curing heads can be operated individually or simultaneously for maximum repair efficiency

Constant controlled heating elements maintain optimum temperature

Tire repair method:

1, the tire will need to fill the wound surface treatment and clean, well marked.

2, with the wound surface grinding machine to fight hair, an area slightly larger than the wound.

3, raw rubber and gasoline will be a good tune glue (or fill with hot glue) with a brush evenly on the hair at the fight.

4. Cut a proper size of raw rubber, it will fill in the wound, if the wound is large, the raw rubber overlap it.

5, the hot head pressure on raw rubber (if possible can pad a thin layer of aluminum or iron in the raw rubber), try to align the center of the wound hot head, pressing screw, fixed tires.

6, turn on the power switch, power indicator light.

7, open timer switch, set at an appropriate position. Cold start can refer to "7", the heat start time can be a little shorter, if you do not need timing can be set on the manual gear, then the hot head to work.

8, at the end of vulcanization, tire repair machine automatically cut off power supply hot head.

9, artificial turn off the power switch, loosen the screw tire pressure, carefully remove the hot head, remove the tire, complete Tyre had

Precautions:

1, the power cord must be safe ground, the power supply is preferably provided with leakage protection switch, you must turn off the power when replace the fuse.

2. Handle with care when removing hot head, to avoid burns.

3, the device Keep away from acid and other corrosive materials.

4. If you need to fill the tube elongated wound, to be equipped with an oval plate, while marked with small eyes at both ends of the wound to prevent cracking inflated leak.

5, after the head if you use hot sticky dirt, use sand to polish the skin clean, otherwise it will affect the flatness of Tyre, and smoothness.

6, the machine six months warranty and lifetime maintenance

Package Included:

1x Tyre vulcanizing Machine