Official PayPal Seal
 

NOTE: This listing is for 1 
brushed aluminum/machined 
finish stack. 

Sorry for any confusion with the pics.
you get 1 stack per order.



*NOTE: These are measured for fitment by the mounting diameter on the carb,
             not the carburetor bore or throat size.
 
Also note:  These come equipped with the higher flow rate,
             Stainless Steel silver screens.


 

you get: 1 full-taper Type velocity stacks per order,
with mounting setscrews and debris screens also included.
~ you will only need an allen wrench to install them,
small size:  3/32"
 

for  TM32 TM34   (and other 58mm OD carbs)
76mm or 3" in length
58mm ID at carb attachment opening
 


These are made specifically for
TM32 TM34's and other 58mm carb mounts.

 

There are no better designed velocity stack, at any price!


ssmith377 at socal dot rr dot com

I also have VM stacks, and MIKUNI stacks, CB750 stacks &

many more:
https://stores.ebay.com/CycleSmith-parts-accessories?_dmd=1&_nkw=velocity

-----------------------------------------------------------------------

Color/Finish: Machine finish Billet Aluminum
 
Fits:    58mm carb mouth diameter.
 
Material:   Billet Aluminum, held with setscrews

-----------------------------------------------------------------------------------------------------------------------------
 


Q:  what are the jetting specs for an xxxxx ?

A:
Sorry, i don't know the exact jetting specs for your specific bike. --as you may know, XS11's used various carbs with different jet sizes from 78-82.
Also, note that every bike is different, and important factors, such as what exhaust you're running, and your elevation, engine condition, etc. all have an effect.
On my XS1100 with stock exhaust, here in CA at about 1000 ft above sea level, i didn't have to rejet, (chage jet sizes) we just adjusted the carbs-
idle mixture adjustment, possible needle adjustment and finally a good carb synch (synchronization).
But a bike with drag pipes or 4:1 is going to be very different!!!!

Check an online forum, someone out there has the same year bike, with the same intake and exhaust setup as yours, and you can get
their jetting specs.


-----------------------------------------------------------------------------------------------------------------------------------------------
 
  ACTUAL EBAY FEEDBACK:



Buyer: loski23 (426)


A+ again                                                                                                                                             Buyer: donerightautomotive (1044)
MIKUNI TM32 TM34 58mm TM Velocity stacks Machined Velocity Stack sold each 58mm 

 
Great seller with quality made parts, Thank you.          Buyer: Member id ossa909 


During past month
 MIKUNI VM30 VM34 58mm 58 mm Velocity stacks Machined Velocity Stack set of 2

The parts fit perfectly on my Custom Cafe with VM's. I could not be more pleased!Buyer: During past month
  

Excellent product and service, highly recommendedBuyer: Aug-14-14 04:27
 

Thanks again!!!!!!!!!!        
Buyer: Jun-05-14 13:05
  




Contact me with any problems.
Buyer to pay initial shipping cost as well as return shipping if returned
for reasons other than defective item.

Please contact me before leaving neutral or negative feedback!
I have a 100% feedback rating !
as always, ask questions first before buying!