BROWN TRIPOLI CUTTING COMPOUND

METAL BUFFING COMPOUND MATERIAL

FAST CUTTING REMOVAL OF SCRATCHES

1 BAR 6"x 2" x 1-3/4"

The Brown Tripoli is formulated for fast cutting, it’s composition is made for removing lines and marks on surfaces, recommended to remove and eliminate scratches and imperfections.

Brown Triploi compound works on all metals as well as plastics. Tripoli is a good cutting compound especially for aluminum, brass, copper, zinc, plastics and soft composites.

NOTE: We have included polishing recommendations at the bottom of this page, to assist you.

BROWN TRIPOLI  COMPOUND  JETS Product # 1614-203    Made in USA

- Bars Size: 6" x 2" x 1-3/4" - 150mm x 53mm x 45mm

- Bar Weight:  Approximately 10oz +/-

·        Utilizes Quality Grade Abrasives

·        Combined with Additives

·        Long Lasting Composition

·        Good Adhesion to Buffing Wheels

·        Minimal Residue

·        No Discoloration

·        Produces - Fast Cutting

SALE IS FOR 1 BAR

SHIPPING: Via USPS MAIL FIRST CLASS 

NOTE: Visit  JETS INC. ebay Store Listings, where you can see the compounds for various Metals and Applications, Polishing Compounds, Felt and Muslin Buffs and Buffing Wheels and a selection of  Jewelers Equipment Tools & Supplies.  JETS Inc.

POLISHING RECOMMENDATIONS:

Our recommendations and suggestions on Buffing to obtain the best results possible: 

·        Use the right compound for the metal that you are trying to polish

·        It may be needed to go through 2 or 3 steps, in polishing to get the optimum result you are looking to achieve.

·        Make sure that the parts that are being polished are smooth and clean, use the appropriate abrasive to remove lines and scratches.

·       Avoid using different compounds with the same buff, if you have to then make sure to clean and remove any hardened compound residue on the surface edge with a buff rake.

·        Segregate your buffs for the various metals, Gold, Silver, Brass … try not to use the same buff for all metals.  If you have to then make sure buffs are cleaned (dressed) with a buff rake.

·        A clean buffing wheel edge is important.

·        Allow the buff and compound to perform the work they were made and formulated for, excessive force or pressure will hurt the process.     

·        Whenever you are working with Platinum never use a buff that was used for another type of metal.

WORK SAFE!   Working with rotary motors and wheels can be dangerous if proper safety procedures are not followed. 

PROTECTION - Protect yourself, your fingers and hands, your face and eyes and use respirators.

  1012 E15 CKSP M