---

Nursery Rocking Chair Conversion Kit for IKEA Strandmon
Easy-to-install kit for converting an IKEA Strandmon Wing Chair into a rocking chair for the nursery. Made in the USA.

Every nursery needs a rocker so Mom can relax while nursing. Installing the runners won't damage your chair, and it's just as easy to remove them and convert the chair back into a standard armchair for your living room.

Why oak
Oak runners are built to last — they resist splitting the way pine runners do over time, and their classic design won't go out of style.

What's included

• Two bent oak rocker runners
• Four screws (for installation)
• Drill bit (for installation)
• Illustrated instructions
• Floor protection pads

Size

• Length: 37-1/4"
• Height: 1-5/8"
• Width: 1-1/2"

Before you order: measure your chair
IKEA Strandmon chairs vary slightly in leg spacing, so please check your measurement before installing:

1. Turn your chair upside down
2. Using a tape measure, measure from the center of the front leg to the center of the back leg (either side — measure at the point where the legs touch the floor)
3. Most chairs measure 21-1/2", but it can vary

Message us through eBay with the measurement if it's other than 21-1/2".

Please note

• The chair shown in photos is not included
• Strandmon chairs purchased after April 2015 have subtle design changes that can cause the chair to lean too far back with this kit. If that happens, simply switch the front and back legs with each other before installing the rockers.