UPGRADE YOUR REAR END. NO WELDING REQUIRED. 🏎️💨
Ditch the rusty factory tailpipe. This premium Carbon Fiber exhaust tip is the easiest way to give your car or truck an aggressive, custom look in less than 5 minutes. No trips to the muffler shop, no welding—just slide it on and tighten the clamp!
THE CUSTOM SHOP SPEC:
Real 3K Carbon Fiber: Features a thick 2mm real carbon fiber outer shell coated in a high-temp, UV-resistant clear gloss to prevent fading and yellowing.
SUS304 Stainless Core: The inner tank is constructed from high-grade SUS304 stainless steel. It won't rust, deform, or corrode from exhaust condensation.
Specs: 2.5" (63mm) Inlet Diameter | 3.5" Outlet Diameter.
Easy Install: Built-in heavy-duty clamp. Just slip it over your factory pipe and tighten with a wrench.
CONDITION: OPEN BOX / LIKE NEW. This tip was acquired at auction in its original packaging. It has been hand-inspected to confirm the carbon clear coat is flawless, the inner stainless is clean, and it has never been clamped onto a vehicle.
⚠️ CRITICAL FITMENT WARNING: MEASURE BEFORE YOU BUY! This tip has a 2.5-inch inlet. Your vehicle's factory tailpipe MUST have an OUTSIDE DIAMETER (OD) of 2.5 inches or slightly smaller for this to slide over it. Please grab a tape measure and check your pipe before ordering!
WHY SHOP CUSTOM SHOP BY JOSH?
1-Day Handling: I ship faster than a straight-piped V8.
Real Enthusiast Photos: No stock photos here. I personally verified the carbon weave on this tip is 10/10.
Pro-Tip: After clamping it down, drive the car for a few days to let the exhaust get fully hot, then get back under there and re-tighten the clamp! Heat cycling can loosen bolts.
Look good. Drive smooth. Stay safe.