Knight PA amplifier converted to
Guitar and Harmonica Amp
Here is a 1939 Knight Model 8W by Allied Radio Corporation.
The schematic lists it as the “#8 Watt Standard” amplifier. The schematic shows
that it was designed 2/8/1939. That is before WW2! The on/off switch is the
tone control, just as it came from the factory.
This is a single ended amp that uses two metal preamp tubes
with grid caps on top, the first being a 6J7 pentode and the second being a 6F5
single triode. The power tube is a coke bottle shaped 6L6G and it sounds great!
It used a rather rare 5Y4G coke bottle shaped rectifier tube, so I wired the
tube socket so you can use the 5Y4G or any more common 5Y3 tube. The 6L6G Is
missing it’s guide pin, but tested so good that I indexed it properly and it is
in the amp.
It has been updated with new shorting input jacks, and
output jacks for both 4-ohm and 8-ohm speakers. The power cord has been
replaced by a properly grounded power cord. The unnecessary powered microphone
and field coil speaker circuitry has been removed. Of course, all the
electrolytic capacitors have been replaced. I did leave in the power resistors
for the powered microphone as they serve to drain the electrolytic caps for
safety.
Check out the picture of the original 8 UF, 500 Volt
capacitor and it’s modern, smaller in size but larger in capacitance 22UF, 500
Volt replacement. Technology has really improved over all these years!
I changed the 6J7 first preamp tube voltage divider and screen grid resistors
to lower the gain as it was overpowering the output and going into distortion
at about 9:00 on the volume control. Now it starts to distort at about 1:00
with a humbucker pickup on the guitar. I also installed a 750-ohm 35Watt
resistor right after the choke to cut the B+ voltage as it was way over the
rating for the 6L6G power tube. The rest of the circuit is just the way it was designed back in 1939 although some of the power supply electrolytics are larger
in capacitance. I paralleled the white ceramic resistors to get it biased at
90.5% which is warm for a single ended 6L6G, but it sounds better there.
I also replaced both the Mic/Guitar and Phono/Harp volume
controls as they would not clean up. The Phono/Harp input skips the first
preamp pentode so as to not overdrive the output with the hotter Harp mics which is the way harmonica players usually use the amp.
This amp sounds great and looks even better. Sure, it shows
use of the 87 years since it was built, but it still has a great classic look!
I will provide an original scan of the schematic from the
bottom of the amp. This was very dirty and unreadable. I could not find a
schematic for this amp anywhere, so I worked at cleaning up this one so that at
least we have something to work with. I will provide one unmodified copy and
one that shows what I have changed in the amp.
You could be the envy of all your friends with this amp that
is older than their grandfather!
And I pay the shipping cost if you live in the continental USA.
Look at my other offerings on eBay.