Please check the width of your jack as shown in the second photo to ensure the correct fit. For other brands of jack pads, please see my other listings.

These trays replace the metal cover that hides the hydraulics on Daytona floor jacks. These are 3D printed with a fairly hard TPU (polyurethane) to make them very durable, chemical resistant, UV resistant, and heat resistant.

Installation:

Simply remove the 4 screws holding the factory cover in place, and then reinstall them into the tray. You can use M5 nuts the help hold the screws in, but this is not necessary for most applications as the rubbery material usually holds the screws in well enough.

Size:

Please check the size chart and make sure that the outside diameter of the saddle on your jack matches to make sure it fits correctly. If you do not see your size or are unsure if it will fit your jack, let me know.

Other colors may be available upon request, but may cost extra and take longer to make and deliver. Please ask and I can make a custom jack pad for you.