Heater & A/C Blower Motor Resistor Pack (Fan Speed Control)
Renault Megane II (X84) • Listed for 2002–2008 • eBay item: 205904079772
This is the exact part pictured. Please match your current part to the photos (shape + plug + mounting) before ordering.
✅ What this part does (and why it matters)
Controls cabin fan speeds by regulating power to the HVAC blower motor (heat & air conditioning airflow).
Fitted inside the HVAC air duct near the blower motor so airflow helps cool it (it runs hot by design).
When it fails: fan may only work on one speed (often max), speeds may drop out, fan may cut in/out, or you may notice a hot electrical smell / heat damage at the connector.
Fitment verified by photos. If you’re unsure, message us your registration/VIN and a photo of your old resistor & plug — we’ll help confirm before you order.
📌 Quick facts
Used part • inspected
Category: HVAC Blower Module / Resistor
MPN / OE: not shown on listing
Known donor marking: “Megane 2005 1.9 dCi” (see photo).
Warranty: 3 months seller warranty.
Returns: accepted (please read fitment & condition notes below).
📷 Actual part photos (match your old part to avoid returns)
Photo 1: Actual resistor pack (this listing). Match the housing + mounting ears.
Photo 2: Donor marking visible on the part (Megane 2005 1.9 dCi).
Photo 3: Assembly + connector view (match your plug and wire layout).
Photo 4: Wiring length & connector position overview.
🧭 Where this part fits in the vehicle (reference photos)
Typical location (Megane II): passenger side dashboard / footwell area near the blower motor housing.
Access is usually via removing the lower trim (and sometimes the glovebox). Always compare with your car before dismantling.
Reference photo A: Megane II interior (passenger-side dash / glovebox area).
Image credit: TuRbO_J (CC BY 2.0) via Wikimedia Commons.
Reference photo B: Megane II dashboard reference (blower resistor is behind/under passenger-side dash area).
Image credit: Marce572 (CC BY-SA 3.0) via Wikimedia Commons.
📋 Fitment & compatibility (read carefully)
No guessing policy: The years below are taken from the listing title and the donor marking shown in the photos.
If your car sits on the changeover years (e.g., 2008), confirm generation by dashboard shape & your old part photo.
| Make |
Model |
Generation / Code |
Confirmed years |
Notes (how to verify) |
| Renault |
Megane |
Megane II (X84) |
2002–2008 |
Match your original resistor pack to the photos: housing shape, mounting ears, plug style, wiring layout.
Donor marking shows 2005 1.9 dCi.
|
Will NOT fit (common wrong orders):
• Megane I (1995–2002) / different dash & HVAC layout
• Megane III (launched 2008) / different generation (some 2008 cars are Megane III)
• Other Renault models (Scenic / Clio / Laguna etc.) unless your old part matches the photos exactly
Before you buy (returns prevention checklist):
1) Compare your old part to Photo 1–4
2) Check your car is Megane II (X84) (interior references above)
3) If unsure: message us your reg/VIN + a photo of your old part for verification
🚗 Vehicle reference photos (Megane II body styles)
5-door hatchback example (Megane II).
Image credit: TuRbO_J (CC BY 2.0) via Wikimedia Commons.
3-door hatchback example (Megane II).
Image credit: M 93 (Attribution) via Wikimedia Commons.
Tip: Your resistor pack is behind the dash, so it can be shared across body styles — but the safest way is still to match your old part to the photos.
🛠️ Fitting instructions (DIY) + tools + estimated time
Required tools (typical):
• Torx bits (commonly T20/T25)
• Small socket/ratchet set (often 7mm/8mm/10mm)
• Trim tool / flat screwdriver (for panels)
• Torch/light + gloves
• (Optional) Multimeter for checks
Estimated time: 30–60 minutes for most DIYers (varies by trim level / access).
If your connector shows heat damage, allow extra time to inspect/repair the plug.
Step-by-step (safe approach):
1) Turn ignition off and disconnect negative battery terminal.
2) Passenger side: remove lower trim panel under the dash (and glovebox if needed).
3) Locate blower motor housing; resistor pack is mounted in the air duct nearby.
4) Unplug connector, remove retaining screws/clips, slide resistor pack out.
5) Fit replacement, secure, reconnect plug.
6) Reconnect battery, test all fan speeds, then refit trims.
Important: A failing blower motor can draw excess current and overheat the resistor/connector.
If your fan is noisy or stiff, inspect the blower motor and cabin filter to prevent repeat failure.
💷 Garage cost estimator (no calculator scripts)
Estimate = hourly rate × time. Use the table below for a quick guide (based on 0.5–1.0 hour typical labour).
| Typical labour rate |
0.5 hour |
0.75 hour |
1.0 hour |
| £60 / hour | £30 | £45 | £60 |
| £80 / hour | £40 | £60 | £80 |
| £100 / hour | £50 | £75 | £100 |
| £120 / hour | £60 | £90 | £120 |
| £150 / hour | £75 | £112.50 | £150 |
Fitting service available (subject to availability). Message us on eBay with your reg/VIN for a quote & appointment options.
⭐ Why buy a quality used part instead of a cheap copy?
Better reliability & correct fit:
Cheap copies can have weaker internal resistors/connectors and may overheat. A properly inspected used part is often the most dependable way to restore factory fan speeds.
Save money AND reduce waste 🌍
Recycled parts are commonly much cheaper than buying new, while also keeping usable components out of landfill.
In many cases, savings can be substantial versus new equivalents.
🌍 Postage & delivery (Worldwide)
This item is sent internationally using eBay’s international shipping programme where available. Eligibility and final costs are confirmed at checkout.
International tracking, customs handling and import charges (if applicable) are calculated by eBay at checkout.
Address policy: Buyers must ensure the checkout delivery address is correct. We dispatch to the address provided at checkout and cannot re-route after the order is placed.
🏬 Collection (7 days a week until 8pm – appointment only)
How to find us:
ThePartCaptain Unit 8–11
(located after Bee Kwik Scaffolding)
Ivanhoe Business Park, Wortley Road
(sometimes shown as Wortley Road for this postcode)
Rotherham, S61 1LZ
Appointments: 7 days a week until 8pm (including bank holidays) by prior arrangement.
Scan for address
QR hosted via qrserver.com
🔧 Repairs & fitting (subject to availability)
Workshop support available (subject to availability).
Photo: Joseph Pillado / Unsplash.
25,000+ parts in stock on the shelf at any one time.
Photo: Hannah Shedrow / Unsplash.
📦 Packed & dispatched with care
Secure packing and tracked dispatch.
Photo: Ashley / Unsplash.
↩️ Returns, fitment verification & important notes
Fitment help: We can verify fitment if you send your VIN/reg + a photo of your old part.
Checking before purchase is the fastest way to avoid delays and returns.
Returns opened as “doesn’t fit” / “item not as described”:
Where fitment has been clearly provided and/or verified with you before purchase, and the item is returned fitted/marked/damaged,
a deduction may be applied (up to 50%) in line with eBay policies on returned items that have been installed or are not returned in the same condition.
Always compare your existing part to the photos — photo matching is more reliable than item specifics for electrical HVAC parts.
💷 We also buy cars for cash
Nationwide collection • Same-day payment • Quick, straightforward process.
Message us on eBay to discuss your vehicle details.
❤️ Support local & choose recycled parts
Buying from a local small business keeps skills and jobs in the community 🏁
Choosing a recycled part helps reduce waste ♻️ and cuts the demand for new manufacturing 🌍.
Thanks for supporting ThePartCaptain!
Note on manufacturer logos: This template uses ThePartCaptain branding and openly licensed reference images.
If you have written permission/licensing for any manufacturer logos, you can add them as hosted image URLs.