This magnetic holder is designed ,3D printed and assembled by me, I'm one person doing all of it so bear with me :)
Shipping using FedEx or UPS only
Custom Fit: The installation screw is offset by design, there is a 3M "no mess" double sided tape to ensure that's secured, the magnet is powerful to hold ball marker in place. If you treat you putter decently then it will hold up fine. you can use your own adhesive if needed.
Durable Build: 3D printed in the USA (Wisconsin), using carbon-reinforced PETG for long-lasting performance, tough to 3D print material but outperform PLA which will fall apart. The 3M double sided tape dot is strong yet leaves no residue when taken off.
If you treat you putter decently then it will hold up fine.
Lightweight: Weighs just 16 grams with the marker.
How to install: It's simple, make sure your grip end is clean and dry, ideally, use alcohol to wipe it clean, remove the 3M tape red cover, screw the attachment on to the grip hole until the screw is all the way in, line up the attachement perfectly with the end of the grip shape, firmly push on the 3M tape dot to make sure good adhesion, slide the Ball Marker in the slot and that's it. you can also your preferred glue or permanent resin glue.
How to remove it:
Start by pulling the holder and unscrewing it off of the grip carefully, Make sure the tape not holding the attachment before unscrewing it, removed the "no mess" 3M tape and you are all set.
3D Printed to last : printed specifically and efficiently to avoid layer separation.
Magnetic Ball Marker holder.
Do not include the actual grip. Do not include Ball Marker