Bjorn sculpted by Printed Ponies and printed by me, Holly Lenz, using an Elagoo resin printer and ABS-Like Printer Resin. Measures approximately 2 3/4” tall (maybe a stablemate size pony). I do have commercial rights for this piece.

Photos are of actual piece being sold, so please review them carefully for any flaws before purchasing.

I hope you love my resin prints! I do not think this model is sticky, and it can be prepped and primed as is. It has been cleaned with denatured alcohol and cured in the sun. However, if you disagree, it can be cleaned further with soap and water, or if that is insufficient, you can clean it with denatured or isopropyl alcohol.

This print is unfinished. 3D prints can be prepped and primed just like any other resin. I personally sand as needed, wash and dry the print then use a spray primer. I paint with acrylics and finish with a mat clear-coat then gloss eyes. If you have any questions about finishing your prints, let me know as I am happy to help. I advise keeping prints out of sunlight until after you have primed them or finished them with a uv resistant clear-coat.

I have pets, and pet hair gets on everything including my 3D prints. I apologize for the inconvenience this might cause. Hair can be removed with tweezers.