PRESSING INSTRUCTIONS

How to apply

STEP BY STEP GUIDE

1. Firstly, ensure your shirt is free from creases.

2. Position the patch or name set on the shirt (Glue side facing down),ensure it’s in the right position (Can use a ruler to measure out the correct distances and ensure symmetry)

3. Use a temperature of around 130-140 degrees celsius on the heat press machine.

4. Place a Telfon sheet over the patch before pressing 

5. Apply firm pressure for 15-20 seconds

6. Peeling from the corner off the outer plastic layer (Only do this when the patch has cooled down)

7. If the patch or name set isn’t fully applied on, press for an additional 15 seconds and repeat the above process

8. Avoid washing the shirt immediately after printing. A minimum of 24 hours is recommended.

Alternatively, you can use a hand iron to conduct the process above, however a heat press application is strongly recommended.

Please advise that I cannot take responsibility for any damages during the application process. If there are any questions or hesitations, Please feel free to get in contact.