The resin 1:1 mix ratio by volume, kit volume is volume mixed, is the total volume
500ML kit : 250ML resin A + 250ML hardener B (Total 500ML)
1L kit : 500ML resin A + 500ML hardener B (Total 1L)
2L kit : 1L resin A + 1L hardener B (Total 2L)
4L kit : 2L resin A + 2L hardener B (Total 4L)
8L kit : 4L resin A + 4L hardener B (Total 8L)
Tips for operation
This product is 1:1 fast cure resin, each time mixed, pour No more than 150ml total, (that is 75ml A + 75ml B, A must be ≥ B), with a thickness range of ≤1.2" to avoid bursting.
and you can go as deep as you like,just make sure to work in stages. stay under 1.2" per pour. after the surface film cures begin your second pour.
the surface set time is roughly 1 hour at room temp.
the full cure time is within 24 hours at room temp 25℃
the hardness range is 70-80D after full cure
Perfect for indoor use like tabletops, fiberglass work, small castings (under 1.2" /3CM), electrical potting, jewelry making, concrete - pebble coating,
marine applications- boat building, & wood water proofing - repairs.
Features:
Mix Ratio...............1:1 by volume
Work time ..............40-60 minutes
Hardness....................D70-80
Mixed Viscosity..........2500-3500cps.
Chemical Resistance.......excellent
Moisture Resistance........excellent
FDA Compliant / Food grade: Yes, in its inert fully cured state
Heat resistance: up to 80℃ (please don't leave hot pans on it,a coaster needed)
Approximate Coverage: 1.1㎡ per 4L kit at 0.3cm thickness
Operation steps
1:1 ratio for A&B glue by volume (A can be 2-5% more than B to make harder)
Pour into the mixing cup
Stir along the cup wall and bottom evenly for 1-2 minutes
Add glitter or pigmentand if you need
Slowly pour mixed resindown the mold
Add other decorative
Important
This chemical needs to be stored in a dry, safe, temperature controlled environment. Always keep the lids tightly sealed when not in use.
Remember, oxygen and moisture oxidize and can rapidly degrade the epoxy and hardener. Moisture is also a potential issue. Always keep the bottles sealed when not in use.
When applying this product, use gloves, goggles, and proper safety equipment. Please refer to the safety data sheet before using any of our epoxy products.
