Description:
100% brand new
Name: front and rear lights
Material: PLA+Plastic
Specification: Front Lights + Rear Lights
Suitable for model:For ARRMA 1/14 Mojave GROM RC

Features:
ARRMA 1/14 Small Mojave Mojave GROM RC RC remote control electric desert card short card conversion front and rear lights. Product received in loose condition. The front window light is curved, when installing, you need to remove the two screws in front of the roof scuff bar, and then use the screws that come with the product. Reinstall from the removed position down.
Refer to the product detail picture. The green arrow marks the screw position. Put the front window light in it and fix the screws with the right holes. Don't screw hard when you feel it will be more laborious to install the screws to the head. Avoid slipping teeth.
The plug of the lights should be put through the back of the mannequin from the position of the rear fender.
The rear taillights are a tight fit and require the light bar to be tucked inside one of the frame structures on the stock rear end.
There are two concave slots in the outer contour of the light housing. Snap into the uprights on either side. Then use the product matching two small snap, factory and tail light body shell for the pre-installed state, the installation needs to loosen the screws of the snap, stuck on both sides of the column after re-installing the small snap. Can be realized fixed.
With double-sided tape for wiring to avoid wire wear by the tire.
Refer to the detail picture for wiring. Directly occupy the original fan interface. Then connect the fan connector to the product. The female connector of the sub-interface. Can be realized. Light up while not affecting the use of the fan

Package List:
1 set of front and rear lights