Bruce Fresh Finish Urethane Top Coat For Finished
Hardwood Floors, 32oz, W165, RLB9957V3
000988025460
Directions:
Bruce Fresh Finish should be used only on pre-finished urethane hardwood
floors. It is NOT intended for use on hardwood floors that have been waxed with
paste wax or acrylic waxes or maintained with oils or oil based products.
Preparation:
1.
Sweep, dust mop or vacuum the entire floor.
2.
Clean the floor with Bruce Hardwood & Laminate
Cleaner. Spray cleaner directly onto floor or onto mop cover.
3.
Clean one 4′ x 4′ area at a time by using a back and
forth motion with the mop. Finish one area before moving to the next. Do not
allow puddles of cleaner to remain on floor.
4.
Turn the terry cloth cover over to a fresh surface as
it becomes soiled or replace with a new mop cover.
5.
Floor must be thoroughly dry before applying Fresh
Finish.
Application:
To obtain consistent appearance, the entire floor should be coated.
1.
Rock Bruce Fresh Finish container back and forth
several times to thoroughly re-mix contents before opening.
2.
Pour Bruce Fresh Finish into a clean flat pan, such
as a paint roller tray.
3.
Apply with a new, clean, dampened sponge mop or paint
pad. The applicator, even if new, should be thoroughly rinsed before use as
contamination may affect results.
4.
Dip the applicator into the flat pan and gently
remove excess liquid to minimize applying too much product onto the floor.
Spread a thin layer with the applicator in long even strokes in the direction
of the wood grain. We recommend applying Bruce Fresh Finish in small areas, 3-4
floor boards wide, moving down the length of the floor. Repeat this pattern
until the entire floor has been coated.
5.
Avoid applying heavy coats of Bruce Fresh Finish.
Instead, apply two thin coats if necessary. Be sure to allow proper dry time
between coats.
6.
Allow to dry for one hour (longer in humid areas)
before applying additional coats. Light traffic is permitted within 2-3 hours.
Wait 24 hours before heavy traffic or furniture replacement.
7.
Destroy excess materials; do not return to container
or retain product for future use.
Do not use Bruce Fresh Finish more than 3-4 times per year to avoid build-up.
Do not clean with chemical cleaners for 2 weeks following application.
NOTE: Do not reuse container.
Dispose of container and content’s residue in accordance with federal, state
and local waste disposal.