Non-Display Model

IDAS™ Digital Mode Operation
The IC-F1100D can program Type-D single- site trunking and digital conventional modes as well as analog mode per channel. The IDAS digital mode employs 4-level FSK modulation and the NXDN™ common air interface, offering true 6.25kHz spectrum efficiency, higher security and better audio clarity – even at the fringes of the communication range.

The following IDAS features are programmable:
PTT ID (TX)
Individual/group calls
Radio check (RX)
Stun/Kill/Revive (RX)
Remote monitor (RX)
Emergency (TX)
Call alert (RX)
Digital voice scrambler (15-bit)
Status Call (Power ON/OFF status and GPS request)
Voting scan for multi-site conventional operation TX: Transmit, RX: Receive

Intelligent Emergency Functions
To assist in worker safety, the IC-F1100D has three emergency related functions: motion detection, man down and lone worker functions. If one of these functions are activated, the transceiver automatically enters an emergency phase and starts counting down to send an emergency signal. The built-in motion sensor detects its position and states motion and non-motion.

Optional GPS Speaker-Microphone
With the optional GPS speaker-microphone, HM-171GPW, GPS position data can be attached to a voice or data transmission such as responding a GPS request status call.

IP67 Waterproof and Dust-tight Protection
While the body is compact, the IC-F1100D has rugged construction providing superior protection against water (1m depth for 30 minutes), dust, sand, mud and other objects. The radio is also tested to MIL-STD 810 specifications. It can withstand harsh use.

Slim, Compact and Lightweight
The IC-F1100D has a compact 52.2×111.8×30.3mm body and weighs only 260g (with BP-280 battery pack and belt clip). It’s easy to carry around anywhere.

Optional GPS Speaker-Microphone
With the optional GPS speaker-microphone, HM-171GPW, GPS position data can be attached to a voice or data transmission such as responding a GPS request status call.

Easy to Hear in a Noisy Environment
The large 36mm speaker of the transceiver provides clear 800mW* audio. The built-in BTL amplifier increases the audio output power and delivers loud and intelligible voice to a radio operator working in noisy environments.
*Typical with internal speaker.

Built-in 2-Tone and 5-Tone (Analog mode)
The IC-F1100D has built-in 2-Tone, 5-Tone, CTCSS and DTCS signaling capability for analog mode group communication and selective calling. The IC-F1000D/F2000D can be used as an analog transceiver ready for future digital migration.

Long-Lasting Battery Pack
The large capacity waterproof battery pack, BP-280 (2400mAh typ.), provides 18 hours of operating time*. The supplied rapid charger BC-213* charges the BP-280 in 3.5 hours. *Tx: Rx: Standby=5:5:90. Power save function ON.

Other Features:
DTMF autodial memories
MDC 1200 functions: PTT ID, emergency call, radio check (RX) and stun/revive (RX)
Surveillance function
Escalating alarm
VOX capability for hands-free operation
Channel announcement function
Red emergency switch on the top panel

INCLUDES:
Battery pack, BP-280
Belt clip, MB-133
Antenna, FA-SC55V
Rapid Charger, BC-213
Owner Manual

2 YEAR WARRANTY IS PROVIDED AT NO ADDITIONAL COST TO THE BUYER THROUGH ACTION COMMUNICATIONS AND ICOM. Ebay is allowing a 3rd party vendor (Square Trade) to offer warranties which overlap the factory warranty. Square Trade is NOT an authorized ICOM service facility and will VOID your factory warranty if they provide service on this product.