THIS EBAY LISTING IF FOR A BRAND NEW 5HP LEESON INDUSTRIAL GRADE SINGLE PHASE ELECTRIC MOTOR. THIS MOTOR IS RATED AT 5HP, CAN BE CONNECTED TO 230V INCOMING POWER SUPPLY. THIS MOTOR COMES ON A 184T FRAME AND ROTATES AT 1750 RPM. THIS MOTOR IS REVERSIBLE AND CAN BE WIRED TO ROTATE EITHER CW OR CCW. THIS IS AN OPEN DRIP PROOF MOTOR AND IS INTENDED TO BE USED IN DRY, NON-DUSTY INDOOR ENVIRONMENTS. THIS MOTOR IS BACKED BY A FULL 12 MONTH MANUFACTURERS WARRANTY FROM DATE OF SALE. THIS LEESON COMPRESSOR DUTY MOTOR IS PERFECTLY SUITED TO WITHSTAND THE STARTING TORQUE REQUIREMENTS OF INDUSTRIAL GRADE 5HP PUMPS. THIS LEESON MOTOR IS CAPACITOR START AND RUN. NOT MADE IN CHINA. 

PLEASE MAKE SURE THE ELECTRIC MOTOR YOU ARE REPLACING MATCHES THE SPECS SHOWN BELOW BASED ON YOUR EXISTING MOTORS DATA PLATE.

WHY YOU ALWAYS NEED A MAGNETIC STARTER ON INDUSTRIAL GRADE  ELECTRIC MOTORS FOR AIR COMPRESSORS. A MAGNETIC STARTER IS ALWAYS REQUIRED ON ANY 184T FRAME MOTOR AND LARGER. WIRING AN INDUSTRIAL SIZE MOTOR THROUGH THE PRESSURE SWITCH ALONE, IS NEVER A GOOD IDEA, AND HERE'S WHY. PRESSURE SWITCHES DO NOT COME WITH OVERLOAD PROTECTION FROM POWER SURGE OR LIGHTING. IN ADDITION, PRESSURE SWITCHES HAVE VERY SMALL CONTACT POINTS THAT CONNECT TO THE MOTOR. SMALL CONTACT POINTS CAN STARVE YOUR MOTOR OF THE NECESSARY POWER IT REQUIRES TO START AND RUN NORMALLY. MAGNETIC STARTERS NOT ONLY PROVIDE YOU WITH MOTOR PROTECTION FROM POWER SURGE AND LIGHTING, THEY ALSO HAVE LARGER CONTACT POINTS THAT CONNECT TO YOUR ELECTRIC MOTOR. ALLOWING FOR A STEADY FLOW OF CURRENT THAT AN INDUSTRIAL GRADE MOTOR REQUIRES TO RUN AND ESPECIALLY START UP. BY INCORPORATING A MAGNETIC STARTER WILL ALLOW YOUR MOTOR TO LAST MUCH MUCH LONGER. 

PLEASE VISIT OUR EBAY STORE FOR THE BEST PRICE AND SELECTION OF MAGNETIC STARTERS. 

DIRECT REPLACEMENT OF BALDOR L1410T / L1430T

 5HP  -  184T FRAME  -  1750 RPM  -  SINGLE PHASE  -  230VOLT  -  1-1/8" SHAFT DIAMETER  -  2.75" SHAFT LENGTH  -  ASSEMBLED IN MEXICO

PLEASE SEE ATTACHED PICS FOR MOTOR DIMENSIONS AND FRAME DIMENSIONS. IF YOU NEED HELP CHOOSING THE RIGHT MOTOR TO REPLACE YOUR EXISTING MOTOR, WE'RE HERE TO HELP. ATTACH A PIC OF YOUR EXISTING MOTORS DATA PLATE TO THE CONTACT SELLER LINK AT THE TOP OF THE PAGE. 

TECHNICAL INFO:

HORSEPOWER: 5

AMPERAGE: 23 @ 208V  /  21 @ 230V

PHASE:  SINGLE PHASE

VOLTAGE: 208-230  IF YOUR INCOMING VOLTAGE IS 208V OR LOWER, PLEASE REFER TO LEESON 131560

RPM: 1750

TORQUE: 15 FT LBS

BASE:  REINFORCED FIXED STEEL BASE

FRAME:   184T    ALSO REPLACES 182T FRAME MOTORS

SHAFT DIAMETER: 1 1/8" KEYED SHAFT

SHAFT LENGTH:  2.75"

ROTATION:  REVERSIBLE  CW OR CCW ROTATION

FREQUENCY: 60HZ

SERVICE FACTOR: 1.15 @ 230V  ( 1.0 SERVICE FACTOR AT 208V)

ENCLOSURE: ODP  OPEN DRIP PROOF 

CONSTRUCTION: STEEL FRAME

WEIGHT: 86 LBS

WARRANTY: 12 MONTH