|
DC Booster Pump Assembly (for up to 100GPD membrane RO systems, good for 50GPD, 75GPD too). Comparable to Aquatec 8800 and 6800 pumps
part # 752
NOW with BONUS pressure gauge (so you can tell the boost pressure after the pump)
This water booster pump is to boost the input water pressure. It is usually used to increase the input water pressure for Reverse Osmosis systems. (boost pressure from 60 to 80 psi)
The Pump assembly includes: pump, transformer, solenoid valve, pressure switch. The pump turns-on to produce water into the pressure tank, and then turns off when the pressure tank is full or when storage tank pressure reaches 40 psi.
Benefits of using Booster pump for Reverse osmosis systems
· For RO systems, an increase in input water pressure means an increase in water production and water purity
· RO systems will run more efficient, and have less drain water. Since it uses pressure switch and solenoid valve to turn on/off the water input, it can turn-on and turn-off more accurately than the mechanical auto-shut-off valve.
· If you use large water container or open water tank, you can use float switch or level switch to control the operation of the pump as well.
· The transformer included in the package is plugged into regular 110V/60HZ electrical outlet.
Specifications:
| Booster Pump: |
| Boost pressure |
If input water pressure is about 30 to 40 psi, the pump will boost pressure to about 70 to 80 psi for RO systems |
| Water open flow |
1 liter per minute or 0.26 gallons per minute |
| Electrical: |
24VDC, 0.22Amp |
| Connection |
Inlet and outlet, 3/8" FPT, or two 3/8"MPT to 1/4 compression fitting are included (connects to 1/4" tubing) |
| Motor |
Permanent Magnet, 24VDC, enclosed |
| PUMP |
Diaphragm pump, 3 chamber, self-priming. It is able to run dry |
|
Material: Housing |
Nylon |
|
Valves |
EPDM |
|
Diaphragm |
Santoprene |
|
Fasteners |
Stainless Steel |
| Dimension |
diameter = 3.5" , length = 7.5" |
| Solenoid valve |
| Type |
Normally Close (NC) orifice opens when electrically energized |
| Electrical: |
24VDC, Leads = 20 AWG |
| Water pressure |
0 to 120 psi |
| Connection: |
two ¼”x ¼” fitting included: connect to ¼” tubing |
| Mounting |
It has two screw holes for mounting |
|
Material: valve |
Plastic valve body, water contacts only plastic and nylon parts |
|
Solenoid |
brass outside body, stainless steel internal parts |
| Pressure switch |
| Type: |
Normally closed (NC) will cut off circuit when water pressure reaches 40 psi |
| Pressure |
Cut off pressure at 40 psi, maximum inlet pressure 120 psi |
| Connection |
¼” compression , connect to ¼” tubing |
| Material |
Polypropylene |
|
Electrical: leads |
20 AWG, 14” long |
|
Max: |
15A, 250Volts |
| Transformer |
| Input |
110V/60Hz |
| Output |
24VDC 1A |
| Leads |
18 AWG, 5 feet |
|