Polymer Wheel Balancer Spacer Ring for Hunter Wheel Balancers.
 
This spacer ring fits all Hunter wheel balancers equipped with a 40mm shaft.
 
Designed to increase back cone centering pressure when back cone mounting.
 
Essential when using a cone that has a larger diameter then the inside of the hub bell.
 
 
What else can we help you find?
Visit our eBay store!

   
   
   
  Disclaimer- 
  The parts we offer are an O.E. alternative replacement; they are not produced by O.E. Manufacturers such as Accuturn, Bosch, All Tool, Ammco, Coats, FMC, John Bean, Hennessy, Hunter, Kwikway, Hofmann, Snap-On, Van Norman, or similar manufacturers respectively.
 
 
 
Color May Vary
We always send the color shown if we have it available.
When we run out of the color shown, we reserve the right
 to substitute for an identical part of a different color.
Thanks for understanding!