U-EC6 C8051F Emulator Downloader Burning Device w/10pin JTAG Interface Adapter
Product Description
1.It can support the full range of C8051F MCU (JTAG/C2 mode)
2.It can support for IAR, Keil, Silabs IDE and so on debug software.
3.MiniUSB port which can also be used by cell phone / MP3 and other device.
4.Buffer IC between the emulator and the target IC MCU can protect Buffer zone between the emulator and the target IC MCU can protect the target MCU and the emulator more effectively.
5.1-pin on the target board output 3.3V, 10-pin selectable 5V output, please make sure the power output is not short-circuited and not be used in the case of current exceeding 500mA.
6.Software can be upgraded and has free driver above the Winme System.
7.It's compact, and easy to carry.
Emulator interface is defined as follows:
| 1 |
3.3VOutput |
2 |
GND |
| 3 |
GND |
4 |
TCK/C2D |
| 5 |
TMS |
6 |
TDO |
| 7 |
TDI/C2CK |
8 |
NC |
| 9 |
GND |
10 |
+5V/500mA（Internal Jumper Support） |
Just three lines to GND and 4,7 C2 mouth when using microcontroller.
Instructions:
After installed the driver you can use the following settings
Programming instructions:
You just need to install the software
when the hex.files are progrmmed on our promming board.And connect the hardware,then open the software programming.If you are a programmer to write programs also need to compile C8051F online programming software, our reader module supports in-circuit emulation.
Hardware needed:
1.AS399x reader module, above the three-pin lead C2 programming interface (C2CK, C2D, GND), picture shown as following:
2.Reader module matching power adapter, we offer a +3.3 V/4A.
3.C8051 burning device and miniUSB cable
4.To facilitate the connection, you need a 10-pin JTAG adapter plate C2 turn, of course, you can also use DuPont's JTAG programming cable pin connector leads to the 4,7,9
If you need the relevant manual,please contact us.
If you need the UHF RFID kit AS3992 passive reader kit,please refer to the links as below:
https://www.ebay.com/itm/UHF-RFID-kit-AS3992-passive-reader-kit-USB-using-5dBi-antenna-/251353556474?pt=LH_DefaultDomain_0&hash=item3a85d6e5fayou need UHF RFID kit AS3992 passive reader kit,Please click the links as below,
Download
flash programming
when the hex.files are progrmmed on our promming board.And connect the hardware,then open the software programming.If you are a programmer to write programs also need to compile C8051F online programming software, our reader module supports in-circuit emulation.
