Renault Dacia H5H470 1.3 TCe Turbo Petrol Engine 1332cc Original OEM
Full Description:
Original OEM H5H470 1.3 TCe Turbo Gasoline Engine, supplied as imported used engine in good condition. The H5H470 belongs to the Renault/Dacia H5H engine family and is a 1,332 cc (1.3 L) 4-cylinder turbocharged gasoline engine.
Engine Specifications
Engine code: H5H470
Displacement: 1,332 cc / 1.3 L
Fuel type: Gasoline
Cylinders: 4
Induction: turbocharged
Injection: Family of direct injection gasoline engines
OEM Application: Renault / Dacia
Related Engine Family References: Nissan HR13DDT and Mercedes-Benz M282.914 are closely related applications, but should not be considered automatically interchangeable without verifying the exact specification.
Compatibility / Applications
Applications of the H5H470 include the following:
Renault Captur/Captur II
Renault Clio IV
Renault Kadjar
Renault Mégane IV
Renault Escénico IV / Gran Escénic IV
Renault Arcana
Renault talisman
Selected Dacia applications using the H5H470 engine family.
Technical application data also shows variants of the H5H family on selected Renault and Dacia models from approximately 2018 onwards.
Important Compatibility Notice
please do Do not shop based solely on the vehicle model, engine size, or appearance.. Engines in the H5H family were produced with various suffixes and powers, including H5H450, H5H470, H5H480, H5H490, and others. Engine management, turbo specifications, accessories, and other components may differ by variant.
Before placing your order, please check:
exact engine code H5H470
VIN/Chassis Number
OEM Part Number
Model and year of production.
Power output
turbo specification
Sensors and wiring connections.
Sink configuration and assembly.
Transmission compatibility
Emissions specification
The supplied motor will be the unit shown in the listing photographs. Any auxiliary equipment displayed should only be considered included when specifically listed.
Professional installation is highly recommended. Prior to operation, the correct fluids, service items related to timing, cooling system overhauls, oil system priming, and the programming or adaptation required by the manufacturer must be completed.
Please contact us with your VIN and existing engine code before purchase if you need compatibility confirmation.
This listing is for a original used gasoline engine unless clearly stated otherwise. The engine is supplied used and may show normal cosmetic wear, marks, stains, rusting, or signs consistent with previous use.
COMPATIBILITY - BUYER RESPONSIBILITY
Buyer is fully responsible for confirming compatibility prior to purchase. Do not rely solely on the vehicle model, year of registration, engine capacity, or appearance.
Before placing your order, please check:
exact engine code
OEM/Manufacturer Part Number
VIN/Chassis Number
Vehicle model and year of production.
Gasoline Engine Specifications and Power
Turbo/non-turbo specification
Emissions specification
Sink Settings
Engine mounts
Sensors and wiring connections.
Intake and exhaust settings
Transmission compatibility
ECU/immobilizer/programming requirements
If you are unsure, please contact us with the existing VIN and engine code before making purchase.
auxiliaries
The sale covers the engine and only those components specifically listed as listed.
Injectors, fuel rail, fuel pump, alternator, starter motor, air conditioning compressor, turbocharger, harness, sensors, manifolds, steering wheel, clutch, brackets, pumps, and other auxiliary components are not covered by engine warranty unless specifically stated otherwise.
Any auxiliary parts shown installed in the photographs can only be supplied as a convenience item and should not be automatically considered tested, warranted, or included unless the listing specifically confirms it.
MANDATORY PREINSTALLATION REQUIREMENTS
The motor should be installed by a competent professional workshop.
Before the first start, the installer should inspect and, where appropriate, replace or repair:
Engine oil and oil filter.
air filter
Fuel filter
spark plugs
Timing belt/distribution chain and tensioner components where applicable
Auxiliary drive belt
Thermostat
Water pump where condition is uncertain
Oil strainer/collector where accessible
Cooling system components
PCV / ventilation system
Intake system
Turbocharger oil supply and return system, if installed
The lubrication system should be properly primed before the first start.
COOLING SYSTEM
The entire cooling system should be checked before using it. It should be confirmed that the radiator, hoses, thermostat, water pump, expansion tank, cooling fan, and coolant circulation are working properly.
Damage caused by overheating, low coolant level, improper purging, locked radiator, faulty thermostat, cooling fan failure, or installation error is excluded from warranty.
FUEL SYSTEM
Buyer/installer should ensure that the fuel system is clean and free of pollution.
When appropriate, inspect:
Fuel tank
Fuel lines
High-pressure fuel pump
Injectors
Fuel rail
Fuel pressure system
Damage caused by contaminated fuel, incorrect fuel, faulty injectors, fuel pressure failures, or external fuel system problems are excluded.
TURBOCHARGED GASOLINE ENGINES
For turbocharged engines, the turbocharger, oil feed and return, intercooler, intake tubes, and related systems should be checked and cleaned before the first start.
The turbocharger should be properly primed with oil.
Engine damage caused by turbocharger failures, blocked oil supply, lack of oil, foreign object damage, contaminated intercooler, or booster system failures are not considered an internal engine defect.
ECU / PROGRAMMING / ELECTRICAL SYSTEM
Some motors require ECU coding, immobilizer adaptation, adaptation, relearning, throttle calibration, injector coding, or other electronic procedures after installation.
Electrical failures, ECU failures, wiring failures, sensor failures, immobilizer failures, improper programming, or communication errors do not automatically indicate engine failure.
PROBLEM DIAGNOSTIC CODES
A fault diagnostic code alone is not accepted as proof that the supplied engine is defective.
A warranty claim may require:
Full Diagnostic Scan Report
Compression test
Oil pressure test
Cooling system test
Installation invoice
Service receipts
Videos and Photographs
Additional workshop testing when reasonably needed
WARRANTY
Unless otherwise stated in the listing, the warranty applies to the internal core of the motor only during the stated warranty period.
The warranty typically does not cover:
Auxiliary Components
Sensors
Injectors
fuel pumps
Turbochargers
Alternators
Starter motors
A/C Compressors
wiring looms
ECU
Steering wheel
Clutch
frames
Belts
Hoses
Filters
Thermostats
External pumps
Gaskets altered during installation
Labor costs
Recovery charges
Trailer
car rental
Storage
Diagnostic loads
Loss of profits
Consequential losses
This does not affect any rights that cannot be legally excluded.
WARRANTY EXCLUSIONS
Warranty may be declined when damage results from:
Incorrect installation
Incorrect motor supplied due to buyer compatibility error
Do not replace required service items
Incorrect or insufficient engine oil
oil hunger
Excessive heating
Cooling system failure
Incorrect refrigerant
Contaminated or incorrect fuel
External fuel system failure
Turbocharger failure
Incorrect ECU programming
Failures in wiring or sensors
Modified engine or vehicle
Use in racing or motorsports
Excessive pulse
Unauthorized internal repair
Disassembly without approval
Continue driving after an abnormal noise, warning light, overheating, oil pressure warning, smoke, or power loss.
CLAIM PROCEDURE
If you suspect a breakdown, stop using the vehicle immediately and contact us before making internal repairs or disassembly.
Buyer may be required to provide:
Installation invoice
Vehicle frame number
Mileage
Diagnostic Report
Failure codes
Photographs
Videos
Oil/Service Receipts
Compression or oil pressure results.
Other reasonable technical evidence
Do not disassemble or repair the internal motor without written authorization when a warranty claim is being made.
When necessary, the engine may need to be returned for inspection before making a final decision.
RETURNS - INCORRECT ORDER / CHANGE OF MIND
Where permitted by applicable laws and market rules, defect-free returns may be accepted subject to the established return period.
In case of wrong orders or exchange of mind returns, buyer may be responsible for:
Replacement charge applicable when legally permitted
The engine must be returned in the same condition it was delivered and must not have been modified, dismantled, damaged, or improperly installed.
FAULTY RETURNSS
If the engine is confirmed to have a covered internal defect, the solution will be handled in accordance with the terms of the listing, applicable eBay rules, and applicable consumer law.
A refund or replacement is not automatically issued solely because a buyer or shopper claims the engine is defective. Reasonable diagnostic evidence and, when necessary, a return inspection may be necessary.
Buyer is responsible for:
Import duties
VAT/Sales Tax
Customs charges
Settlement fees
Destination rates
Provide any documents requested by carrier or customs authority.
If a shipment is returned because the buyer refuses delivery, does not go through customs, does not provide the requested documents or does not pay the applicable import charges, reasonable costs of departure, return, customs, storage and related may be deducted from any refund where permitted by law and market rules.
Please contact us prior to purchase if you need clarification on compatibility, components included, condition or installation requirements.
Carefully,
Experts 4x4