70-600V Induction Test Pen with Red and Green Indicator Lights and Magnetic Screwdriver Tip
Keep a compact, multifunctional tester in your toolbox with this electrician test screwdriver. The AC non-contact induction function helps you check for the presence of AC voltage, while the screwdriver tip lets you tighten or loosen screws with the same tool.
Bright red and green indicator lights are built into the handle, and a smart circuit board helps the tester respond to detection. The textured grip gives you a firm hold, and the magnetic tip helps to pick up and hold small screws as you work.
Induction testing helps you check for AC voltage without touching the conductor with the tip.
Designed to indicate AC voltage across a 70 to 600 volt range.
Bright lights built into the handle show the test result at a glance.
Use the screwdriver tip for light screw work, with the tester always to hand in the same tool.
The magnetic tip helps hold small screws in place while you fit or remove them.
A shaped, textured handle gives you a secure, comfortable hold during use.
| Product Type | Test Screwdriver / Voltage Tester Pen |
|---|---|
| Detection Type | AC Non-Contact Induction |
| Voltage Range | 70-600V AC |
| Indicators | Red and Green Lights |
| Screwdriver Tip Styles | Slotted (flat) and Phillips (cross), as shown on the product images |
This tool indicates the presence of AC voltage only. It does not measure the exact voltage.
| Specification | Details |
|---|---|
| Brand | Galacok |
| Product Type | Multifunctional Test Screwdriver and Voltage Tester Pen |
| Detection Method | AC Non-Contact Induction |
| Voltage Range | 70-600V AC |
| Indicator Lights | Red and Green |
| Screwdriver Function | Yes |
| Tip | Magnetic |
| Handle | Textured Non-Slip Style Grip |
| Recommended Use | General Household and Workshop Checks |
| Quantity | 1 Test Screwdriver |
Warning: Electricity can cause serious injury or death. This tool is an indicator only and is not a substitute for proper safe isolation. Never assume a circuit is dead because the tester shows no signal. Always follow the correct procedure for isolating and proving a circuit dead.
Only use this tool if you are competent to work safely with electricity. Electrical work in many places must be carried out or checked by a qualified electrician, so follow your local laws and regulations.
Always test the tool on a known live source before and after use. Do not use it if the housing, tip or handle is cracked or damaged, if it is wet, or if the indicator lights do not work. Do not exceed the stated voltage range.
This product is not a toy. Keep it out of the reach of children. Do not use the screwdriver as a chisel, pry bar or hammer. Store it in a clean, dry place. Appearance and packaging may vary slightly.
A multifunctional AC non-contact test screwdriver with 70-600V detection and clear red and green indicator lights. Always follow proper safety procedures.