1/2" Compression Sleeve & Ferrule Puller – No-Cut, Zinc ⭐️⭐️⭐️⭐️⭐️

Description

Model	YEAHDSG
Item Weight	7.7 ounces
Product Dimensions	6.7 x 4.5 x 0.72 inches
Item model number	DSG001
Manufacturer Part Number	YEAH001

Product description

• NO DAMAGE TO WALLS, COPPER OR WATER LINES：This 1/2" compression sleeve puller removes stuck ferrules and nuts without scratching walls, pipes, or fittings. A plumbing tool that keeps your copper intact while pulling off the ring. A prime choice for swapping quarter-turn valves on dishwashers, sinks, and toilets
• SKIP THE PIPE CUTTING：Stop wasting time with saws or torches. This ferrule puller slides easily into cramped spaces where copper is barely visible. Unlike a pipe threading tool, it extracts the old compression ring and restores crimped pipe to a proper circle – leaving copper unmarked. A handy addition to any plumber
• HANDLES FROZEN & STUCK FITTINGS：Machined from hard-wearing steel, this compression ring tool powers through frozen or seized pipe stops without a struggle. Just turn the lever and the old sleeve comes right out. A soild go-to pipe fitting tool for any plumbing repair
• QUICK 4-STEP PROCESS：Step 1: Pull out the old fitting or angle stop. Step 2: Thread the pipe nut onto the golden end and hand-tighten. Step 3: Align the puller, then extract the nut and ferrule in about 10 turns. Step 4: The tool automatically ejects both pieces. No guesswork. No guesswork. No hassle. Just results
• RUGGED, LONG-LASTING DESIGN：The fully machined body and screw deliver worthy wear guarding and rust defense. This ferrule puller handles repeated use on frozen, corroded, or stubborn fittings without losing effectiveness. A no-brainer among pipe tools and plumbing gear for homeowners and DIYers
• NOTE: This compression sleeve puller is made for 1/2" compression fittings only. Please confirm your fitting size before ordering