for Cummins ISX12/15 Front Crankshaft Seal Wear Sleeve Remover/Installer 4918991

4918991 Front Crankshaft Seal Wear Sleeve Remover/Installer for Cummins ISX12 15


Application: Fit for Cummins ISX12 and ISX15 with single overhead cam. 
 
Part Number: 4918991
 
Material:Made from premium sturdy steel, durable and anti-corrosion for providing a much longer service time.
 
Usage: Easy to use, used to remove and install the front crankshaft seal and wear sleeve without damaging the seal, reliably prevent seal leakage and ensure the correct installation depth of the crankshaft seal
 
Package: 
1* Sleeve Remover
3 * Washers
3 * Nuts
3 * Nuts
3 * Studs
3* Forcing Screws
2 * Hex-head screws
6 * Self tapping screw
Easy to Install:  
  1. Place the crankshaft seal over the crankshaft nose and gently press the seal against the carrier with your hand.

  2. Insert the studs through the replacement plate. Slide the long hex spacer over the studs on the inside of the replacement plate.

  3. Slide the replacement plate assembly over the crankshaft nose. Screw three studs into the tapped holes. Install the three washers and hex nuts onto the studs. Tighten the hex nut.

  4. Check the crankshaft seal during installation to ensure it is pressed in evenly. Tighten the hex nuts no more than 12 turns at a time, alternating clockwise directions, until the replacement plate seats against the face of the crankshaft adapter.


     

PushAuction