This eBay listing is for a job lot of 30 axles worth of OO Gauge (16.5mm) Plastic 10 Spoke Wagon Wheels. The wheels are a push fit on to a metal axle with pin point ends. These are generic wheels suitable as replacements on model railway wagons, vans etc.

PLEASE NOTE - As these have been in storage for some time there is some light surface rust to the steel axles. This will clean off no problem and the easiest way is probably by sliding the wheels off, putting the axle in a cordless drill and spinning it up with some fine grade dry abrasive paper. Remember though when you fit the wheels back on you will need to re-gauge the spacing for 16.5mm if OO. A back to back gauge is the simplest way of doing this.

There may be a little flash here and there on the wheels to trim off as they were injection moulded.

Sizes of these wheels as follows:

Tyre Diameter - 12mm

Flange Diameter - 13.6mm

Thus Flange Depth - 0.8mm

Wheel Width at Rim - 2.4mm

Axle Diameter - 1.7mm

Axle Overall Length - 26mm

Back to Back (nominal) - 14.5mm

Due to age and condition - low start and no reserve to reflect this.

Will be sent with Royal Mail Second Class and packaged as to prevent damage in transit. Postage cost is based on small parcel rate as wheels won't fit large letter restriction once packaged up.

Please study the images as they form part of this description.

Sold as seen with NO RETURNS accepted so please be sure it is what you want before bidding or making offers.

Thanks for looking.