Description of product:
1.1 Heater designed for heating composite
resin material,improve the flow of its adhesive properties;At the same
time it can also be used to heat adhesive when used manual equipment.
Heater use the precision circuit control
module to heat,control the temperature tolerance within 1
degree,According to your choice of material and it can set any integer
temperatue within 40-70℃
1.2 Some materials and recommended temperatue
No. |
Material
|
Recommended temperatue(℃)
|
|
1
|
Resin(for filling)
|
39
|
|
2
|
Resin(for bonding)
|
55
|
|
3
|
Branscan
|
38
|
|
4
|
Agar film
|
Melting 99；Insulation 60
|
|
5
|
Sodium hypochlorite
|
60
|
Operation:
2.1 After plug the power supply,the digital tube is always on ” -- ℃ ”
2.2 After plug the power supply,single press “ ON/OFF/SET ”
Heater goes into the heating state according to the set temperatue at previous power-off
It automatically stops heating after reaching preset temperatue.
2.3 After plug the power supply,single press “
+ ” or “ - ” into the setup mode.Press “ + ” can increase the preset
temperatue.Press “ - ” can decrease the preset temperatue.After
setting,single press “ ON/OFF/SET ” into the heating state.It
automatically stops heating after reaching preset temperatue.
Notice:
In the setting mode,long press the “+”or “-”
to quickly increase or decrease the preset temperatue,any integer within
the preset temperatue 40-70 can be selected.
Technical parameter:
3.1 Power adapter：
Input：AC100-240V 50/60Hz
Output：DC15V2A
3.2 Heating temperatue range:40℃-70℃，±1℃
Package List:
1 * AR Heater
1 * Plug
1 * User Manual
FDA Statement:
The sale of this item may be subject to regulation by
the U.S. Food and Drug Administration and state and local regulatory
agencies. If so, do not bid on this item unless you are an authorized
purchaser. If the item is subject to FDA regulation, I will verify your
status as an authorized purchaser of this item before shipping of the
item.
