Fits:

• For Hyundai Genesis 2010
• For Hyundai Genesis Coupe 2010-2012
• For Hyundai Tucson 2010-2013
• For Kia Forte 2010-2013
• For Kia Soul 2010-2011
• For Mercedes-Benz Gl320 2007-2009
• For Mercedes-Benz Gl450 2007-2009
• For Mercedes-Benz Gl550 2008-2009
• For Mercedes-Benz R320 2007-2009
• For Mercedes-Benz R350 2007-2012
• For Mercedes-Benz R500 2007
• For Mercedes-Benz R63 Amg 2007

Specifications:

• Connect Gender: Female

• Housing Material: Plastic

• Terminal Gender: Male

• Terminal Type: Blade

• Warranty:   1 year

• OE #: 934102M010, 934102M015

• Quantity Sold: One Piece

?

• Fitment Type: Direct Replacement

?

• Placement on Vehicle: Steering Column

?

• Color: Shown as picture

Package:

• 1x Turn Signal Switch

Features:

• Mounting and connectors identical to OE
• Built to strict quality control standards
• Direct replacement

​

​How To Replace Window Switch:

• Prepare tools: You need a Phillips screwdriver, a 10mm wrench and a plastic pry bar.
• First, locate the control panel of the door lifter. Usually it is located on the front or rear of the armrest inside the door.
• Use a screwdriver and wrench to remove the screws securing the control panel. This screw is usually 10mm.
• After removing the screws, carefully pry open the control panel cover to separate it from the door lining.
• Next, locate the screws on the lifter motor and remove. This screw is usually on the bottom of the motor.
• After removing the screws, pull out the wire connector connected to the motor. These connectors usually come in the form of plugs that can be disconnected by simply pulling them back slightly.
• At this point, the entire window lift switch has been removed. If parts need to be replaced, you can start installing the new parts. Just follow the disassembly sequence in reverse order.
• Reconnect the wire connector and secure it to the motor. Make sure all connectors are connected correctly to their respective locations.
• Put the lift motor back into place and tighten the screws at the bottom with a screwdriver and wrench.
• Reinstall the control panel cover onto the door lining and secure it in place with a plastic spudger.
• Finally, use a screwdriver and wrench to tighten the screws on the control panel.

​

​Notice:

• Prior to buying, Please check your vehicles compatibility on the chart above . If your car does not appear on the compatibility chart, it is not compatible with your vehicle.
• Prior to buying, Please check your old number and pictures.If your old product pictures is not same with the item picture, it doesn't fit your vehicle.