This 3D printed pipe addresses a common issue when fitting downpipes: steps in the wall. Using two elbow (such as the FloPlast 112.5° elbows) you have a minimum offset of around 100mm. This is often too much and means you need to offset the two sections of pipe above and below the step.
This 3D printed pipe is designed to address this issue using a single section of pipe. The pipe is available with a number of predefined offsets - or simply select 'custom' and specify the offset you require in the comments when you order. The pipe is around 200mm high - but this height may vary slightly depending on the offset selected.
Lightweight and easy to use. Printed in durable PETG.