|
Feature: 1. Long Battery Life: The electric drill is equipped with 2 x 1300mAh batteries, providing long battery life, and is equipped with working indicator light and LED power prompt. Specification: Item Type: Cordless Drill Driver Kit Main Material: ABS, Carbon Steel Equipped Li Battery: 5 Cell 3C 1300mAh Battery Maximum Torsion: 25N.m No Load Speed: 1500RPM Chuck: 0.8-10mm Torsion Gear: 25 Gears Package List:
1 x Cordless Drill 2 x 1300mAh Battery 1 x Battery Adapter 2 x Hex Shank Drill Bit 6-8 3 x Hex Shank Twist Drill Bit 3-4-5 2 x S260 Bit 2 x 50 Single Head Bit (Slot, PH) 1 x 240 Long Universal Soft Shaft 9 x Small Socket 4-12 1 x Transparent Storage Box 6 x Yellow Plastic Anchor 8 x Blue Plastic Anchor Can Be Expanded To 5 Sizes 6 x Red Plastic Anchor Can Be Expanded To 6 Sizes 20 x Anchor (10 x 4x20, 10 x 5x18) 1 x Shaft 1 x Tower Drill Bit 3 x Woodworking Flat Drill Bit 10, 16, 20 1 x Wrench 1 x Strong Magnetic Level Ruler 1 x Instruction Manual Note:
1. Small Workpiece Processing: Small workpieces need to be fixed with pliers/fixture; When drilling 6-10mm holes, operate in gear 1 (low speed). 2. Continuous Use: Keep using until the battery is depleted, let the tool cool for 15 minutes, and then replace the battery to continue. 3. Screw Tightening: Align the drill bit with the screw head and apply pressure, gradually increase speed after starting at low speed; Immediately release the actuator after screwing the screw vertically in, otherwise it may damage the screw/drill bit. 4. Take the Screw: When operating, adjust the switch to the reverse position. 5. Pre Drilling of Wooden Screws: Before tightening wooden screws, guide holes need to be pre drilled (see table for pre drilling sizes of screws with different diameters) to avoid workpiece slippage. 6. Over Temperature Protection: When the load is too high or the battery exceeds 75℃, the tool will automatically shut down and resume after cooling down. 7. Over Discharge Protection: When the battery is over discharged, the protection circuit will activate and the tool will stop running. 8. Disposal of Waste Batteries: Recycling is required, do not disassemble or short circuit; Wrap the terminals with tape to prevent electrical leakage and do not dispose of them casually. 9. Cleaning: Do not use water/cleaners, simply wipe with a dry cloth; Keep the ventilation openings clean. |