| Category: | Electrical Connector |
| Connector Gender: | Male |
| Terminal Gender: | Female |
| Terminal Type: | Blade |
| Terminal Quantity: | 3 |
| Wire Quantity: | 3 |
| NISSAN | CABSTAR | 2012-2016 |
| NISSAN | GT-R | 2009-2025 |
| NISSAN | SENTRA | 2017-2019 |
🔵 © ISUMO® More Than a Brand — It’s Quality.
Manifold Pressure (MAP) Sensor x1
Electrical Connector with Pigtail Wires x1
🔵 DESCRIPTION
The Manifold Pressure (MAP) Sensor measures intake manifold pressure/vacuum and sends the signal to the engine control module for engine-management calculations. This package includes one MAP Sensor and one matching electrical connector with pigtail wires.
🔵 FUNCTIONS
• Measures intake manifold absolute pressure
• Helps the ECM calculate engine load
• Supports proper fuel delivery and ignition control
• Helps maintain smooth acceleration and engine response
• Provides pressure information used by the engine-management system
🔵 COMMON ERROR CODES
MAP-sensor-related codes may include:
• P0105 – MAP/Barometric Pressure Circuit Malfunction
• P0106 – MAP/Barometric Pressure Circuit Range/Performance
• P0107 – MAP/Barometric Pressure Circuit Low Input
• P0108 – MAP/Barometric Pressure Circuit High Input
• P0109 – MAP/Barometric Pressure Circuit Intermittent
Codes can vary by vehicle configuration and scan tool.
🔵 COMMON SYMPTOMS
• Check Engine Light
• Rough or unstable idle
• Hesitation during acceleration
• Reduced engine performance
• Poor fuel economy
• Hard starting or stalling
• Incorrect engine-load readings
🔵 BENEFITS
• Direct replacement design
• Helps restore accurate manifold-pressure readings
• Supports proper fuel and ignition management
• Replacement connector helps repair damaged, brittle, or worn electrical connections
• Designed for reliable engine-management operation
🔵 PACKAGE INCLUDES
• Manifold Pressure (MAP) Sensor x1
• Electrical Connector x1
• Pigtail Wires
🔵 IMPORTANT NOTES
• Professional installation is recommended.
• Verify vehicle application and engine configuration before installation.
• Proper wire splicing and insulation are required when replacing the connector.
• Clear stored diagnostic codes after repair when required and verify proper system operation.
🔵 © ISUMO® Registered Trademark. All Rights Reserved.
==============================================