RV LIGHTING.
The new Maxi Dash Pod light has been designed with a full foam seal to prevent flash back whether using the removeable suction cup mount or self-adhesive mounting option , once fitted this window light is one of the most covert lights on the market.
Supplied with two ways of installation both designed to stop flash back!
1. Suction cup housing with soft foam gasket to prevent flash back
2. Remove the suction cup housing and install the supplied double sided adhesive soft foam gasket for a secure semi-permanent fitting
The main feature is the foam seal that runs around the edge of the pod that stops flash back during low light levels or night-time usage.
• Available in single colour and dual colour with independent control (see Single or Dual Colour Control below)
• Sync multiple units by removing the cigarette plugs & connecting flash pattern wires together
• 2 metres of cable, cigarette plug including on (colour 1)/off/on (colour 2) and pattern switch
• They’re packed with some of the highest powered LEDs.
Main Features:
– 12/24v Dual voltage
– High Power 18 x 1.5 Watt LEDs (single colour) / 24 x 1.5 Watt LEDs (dual colour)
– ECE R65 Class 1 & 2.
– Built-in 19 selectable flash patterns
– Memory recall for last flash pattern used at power up.
– Water and vibration resistant
– Reverse polarity protection
– Supplied with pre-wired cigarette plug. (Can be removed for hardwiring)
– Average current 0.7A @ 12V
– Fixing type: 1 point
– Mounting type: Suction Cup, Self-adhesive
Single Colour Control:
Single colour models are supplied with 2 meters of 3 core cable fitted with a cigarette plug featuring a on/off switch and pattern switch. The cigarette plug can be removed, and the unit hardwired and synced to additional units by connecting the flash pattern wires together.
Dual Colour Control:
Dual colour models are supplied with 2 meters of 4 core cable fitted with a cigarette plug featuring on (colour 1)/off/on (colour 2) switch to control both colours and a flash pattern switch.
For example, a dual colour model using the cigarette plug, switch one could be set to flash amber, switch two set to flash white.
Another possibility would be to remove the cigarette plug and using two on/off switches you could control both amber and white independently and also when both switches are in the on position, both amber and white colours would alternate flash. They can be synced to additional units by connecting the flash pattern wires together.
There are a number of single flash patterns and alternating flash patterns as well as steady burn.
Wiring information for hardwired versions:
Cut and remove supplied cigarette plug to expose the wires of the cable.
Red Wire: Positive, Colour 1 ON/OFF
Blue Wire: Positive, Colour 2 ON/OFF
Yellow Wire: Flash Pattern Select & Sync
Black Wire: Negative, Ground
Dimensions in mm:
– 165L (adhesive mount) / 252 L (suction mount)
– 48 H x 116 D
Approvals:
– E9
– ECE EMC R10
– ECE R65 Class 1 & 2
– IP 52
Warranty:
3 Years manufacturer warranty
Part Number:
MDP-I
Our products are not to be confused with cheap, unreliable products with poor LEDs quality, all our LED products come with at least 2 years warranty and brightness guaranteed.
