BALDOR TAPERED SPINDLES SET of 2

3/8" FRICTION GRIP - RIGHT & LEFT

Fits Baldor POLISHING LATHE

TAPERED SPINDLES - MADE IN USA

The spindle is made to use with a Baldor Dental Polishing motor. Spindle is fits 3/8" Polishing lathes has an inside diameter that is tapered to fit on the tapered shaft of a Baldor Dental Polishing motor. These are specifically made to fit Baldor motor shafts since they are not straight, but have a slight taper.

Spindles are a friction fit, they are pushed on to the shaft of the Baldor motor, to properly secure them onto the shaft, lightly tap with a soft mallet or a piece of wood.  To remove, just use the screw off spindle remover on the motor by simply unscrewing and turning it  until the spindle is pushed off of the tapered shaft.  
.
Spindles is made of cold rolled steel is machined to close tolerances, anodized Black - made in U.S.A.  
.
Spindles have a 3/8" Tapered arbor hole to work on Baldor 3/8" shaft motors lathes.   The spindle arbor hole has a slight tapered to fit and be held on the Baldor Motor Lathes shaft.  Note: Spindle does not have tightening screws. 
.
FEATURES:
· Precision Quality
· Machined - High Speed Lathe
· Made from 3/4" Stock Material
SPECIFICATIONS:  JETS Product # 1603-112370 & 212370
· Material: Cold Rolled Steel Anodized Black
· Overall Length:  3-1/2" - 90mm
· Spindle Body Length: 1-3/8" - 35mm 
· Spindle Tapered Length: 2" - 51mm 
· Arbor Hole: 3/8" Tapered Friction Grip to Shaft  
· Weight:  2.75oz. each

Spindle is made to be used on a 3/8" tapered shaft diameter marked R - Right Hand Side and L - Left Hand Side of Motor with forward direction.

NOTE: Visit JETS INC. our ebay Store where you can see listings of various Commercial Grades of Spindles, Arbors, Miniature Mandrels and Holders along with more Jewelers Equipment Tools and Supplies. JETS Inc.

B61125 CKSP