Taylormade Spider X Bottom Plate Combo

Upgrade or customise your Spider X putter with this precision 3D printed bottom plate insert along with the putter insert and back plate.

This custom bottom plate is designed specifically for the Taylormade Spider X putter and offers a clean, modern replacement for the original insert. Manufactured using high-quality 3D printing techniques, it provides a lightweight yet durable part while helping golfers personalise the appearance of their putter setup.

The insert is designed to fit using the existing screw positions from the original back plate, meaning no additional hardware is required. Whether you are refreshing a worn component, customising your putter, or experimenting with a unique setup, this replacement plate delivers a precise and professional-looking finish.

Each plate is made to order and may require very minor fitting adjustments depending on your specific putter model or personal preference. Multiple colours and material options may also be available upon request.

Key features

• Designed for the Taylormade Spider X putter
• Precision 3D printed replacement bottom plate, insert and back plate
• Uses existing screw holes for installation
• Lightweight and durable construction
• Ideal for custom builds and putter restoration

What’s included

• 1 x Taylormade Spider X bottom plate insert.
• 1 x Taylormade insert in any colour
• 1 x Taylormade Backplate blank - Styles to be disccused at time of purchase.

Important Information

• Putter is not included
• Screws are not included as original screws are reused
• Minor fitting adjustments may be required
• As these are made-to-order items, returns are not accepted
• Please ensure compatibility before purchasing

Installation guide

Backplate

1. Remove the original back plate from your Spider X putter, there are 2 screws hidden behind the putter insert along with the 2 visible.
2. Position the replacement insert into place.
3. Reuse the original screws to secure the plate.
4. Check fitment and make any minor adjustments if needed.

Insert

1. Remove old insert using heat or pry it off.
2. Clean the area with IPA to remove the glue, or use an alternative.
3. Check fitment, if added height is required then please use painters tape. (only in rare cases).
4. Apply Glue to the area where the insert will be seated.
5. Push the insert down into place can apply pressure until dry.

Back plate

1. Remove old back plate.
2. Clean area of glue
3. Use glue to stick the back of the plate to the putter.

Please note: This listing is for the replacement bottom plate, insert and back plate only. The putter shown in the images is for demonstration purposes only.