There are 2 of them available, amplifiers are with some marks of wear over the years. Will be professionally serviced, tested, cleaned, and replaced components only that were out of spec. Most parts are still original.
Description
The FMJ P7 Power Amplifier is the perfect partner for the AV9, but will also complement the performance of any other high-quality preamp processor. Its sleek enclosure delivers over a kilowatt of raw power from seven channels: all THX Ultra rated at 150 watts. It has been designed to deliver reference standard amplification in high performance audio-video installations. The P7 is a true audiophile powerhouse, and it offered the most advanced performance of any Arcam amplifier made at the time.
A completely modular design, with 7 identical and fully isolated power amplifiers, these may be daisy chained for bi-amping or tri-amping suitable loudspeakers. Each amplifier module has its own bridge rectifiers and 20,000 microfarads of storage capacitance, fed from a total of 14 individual windings on the P7’s two massive 1500VA toroidal power transformers. This arrangement ensures near perfect isolation between the channels for the avoidance of hum loops. It also means that each channel can always deliver its fully rated continuous output power of 150 Watts into 8 ohms or 230 Watts in 4 ohms, irrespective of what the other channels are doing.
The advanced current feedback circuit topology used in the P7 is a further development of that used in Arcam’s award-winning A85 and A32 amplifiers and has ultra low distortion together with exceptional dynamic range and transient response.
As well as being technically superb, great attention has been paid to the aesthetic design of the P7 to ensure it will look stunning in a home installation.
The P7 represents a tour-de-force in amplifier design. Certain to enrich your listening experience, its abundant power and finesse firmly positions Arcam in a small, select group of world-class producers.
150W x7 (into 8ohms; 230W x7 into 4ohms), modular design. - Each amp module—one per channel—includes rectification and 20,000F of storage capacitance, fed by two 1500VA toroidal power transformers. This ensures that each module can deliver full output at all times. - Made in the UK
FMJ P7 7-channel, THX Ultra2 power amplifier Inputs: 7 RCA (single-ended) Outputs: 7 RCA (pass-through), 7 pairs 5-way binding posts Output: 150Wpc @ 8ohms, 230Wpc @ 4ohms (20Hz–20kHz) Peak output current: >22 amps per channel THD: typically, <0.005% @ 1kHz; <0.05%, 20Hz–20kHz @ any level up to rated power into 4ohms or 8ohms Frequency response: 20Hz–20kHz, +/-0.2dB; –1dB @ 1Hz, 100kHz Residual hum & noise: typically –112dB ref. full power Voltage gain: x28.3 (1V input gives 100W output into 8ohms) Input impedance: 22kohms in parallel with 470pF Output impedance: 50milliohms @ 20Hz, 1kHz; 120milliohms @ 20kHz Power requirements: 115V or 230V AC, 50/60Hz, 3kW maximum via heavy-duty IEC mains inlet; soft-start system eliminates large currents at turn-on Dimensions: 17" x 7.1" x 18.1" (WxHxD) Weight: 77 lbs --------------------------------------------------------------------------------------------
Disclaimer: Although I take every precaution in managing my hi-fi and hi-end products, there is a possibility that small scratches may occur during display and storage. I try to check and describe them as much as possible, but I cannot guarantee that every single part is genuine products. Additionally, what is in the image is all that is in the product. Please be sure to check the image as the current state of the accessories and exterior condition will take precedence. I try to describe the condition of the product, such as scratches, sunburn, and dirt, as much as possible, but I may overlook them. It is not realistic to perfectly describe all of the product conditions. Therefore, please be sure to check the condition of the product in an enlarged image. Scratches, sunburn, dirt, etc. that can be seen in an enlarged image are not a reason for return. I do not accept returns due to minor scratches, sunburn, dirt, etc. that are difficult to see even in an enlarged image. What is in the image is all that is in the product. Scratches, dirt, defective screws, peeling of glue, etc. on the inside and bottom that are not photographed. Deterioration due to aging. These parts that do not affect the function of the audio equipment are not covered by the warranty.
READ CAREFULLY A FOLLOWING DISCLAIMER:
Keep in mind the amplifier will be tested again prior shipping and items damaged during transportation has no insurance or warranty, no return will be accepted. Posting insurance can be offered for additional fees as price is set as a minimum for the posting