Note: This listing does NOT include an ESP32, cable or mounting screws.  See my other listings to purchase an ESP32-S3-WROOM-1!

Note: These cases require your ESP32 to have no pin headers attached.  If header pins are attached, it will not fit!

Fits these modules...

• ESP32-S3-WROOM-1
• Please get in touch if unsure!

This case has been subject to masses of over-engineering and features:

• PETG construction : making the case more heat resistant and tougher than others printed in PLA.
  
• Air vents to dissipate the heat from your hard working ESP32.
• Thumb notch to pop off the bottom panel, exposing the pins of your ESP32.
• 2x USB-C slots for easy access to power or computer connection.
• Unique design : Hobby Stuff designed this from scratch (over far far too many hours!).
• Chunky : This case is a tough little thing with a 2mm outer wall.
• Shimmering finish : Our favourite part of it all.  The top and bottom surfaces look brilliant in our opinion.  They sparkle under the right light.
• Fits ESP32-S3-WROOM-1.

Tell me more about the case:

The case is 3D printed in PETG.  It's snap fit with fingernail-notches to pop it open once shut.

Are the parts new?

Yes!  These cases are 100% designed and manufactured by Hobby Stuff, and sent directly to you.  They are kept pre-made so there is no manufacturing delay when getting them shipped to you!