AJD-3 temperature adjustable curing press car tire fire mending machine
1. Clean the wound surface of the tire to be repaired and make a mark.

2. Use a sander to roughen the wound surface, with an area slightly larger than the wound.
3. Apply the glue (or hot repair glue) mixed with raw rubber and gasoline evenly to the roughened area with a brush.
4. Cut the appropriate size of raw rubber, and fill it in the wound. If the wound is large, the raw rubber can be overlapped.
5. Press the hot head on the raw rubber (a thin layer of aluminum plate or iron plate can be placed on the raw rubber if possible), aim the wound at the center of the hot head as far as possible, press the screw rod tightly, and fix the tire.
6. Turn on the power switch, and the power indicator is on.
7. Turn on the timing switch and set it at a suitable position (if the timing mode is not used, it can be set at the manual gear). At this time, the iron starts to work.
8. At the end of vulcanization, manually turn off the power switch, loosen the tyre pressing screw, carefully remove the hot head, remove the tyre, and complete the whole repair process.