This listing is for 2 foams (pair) and a set of front gaskets. These gaskets are the closest I have found to match the appearance of the original Cerwin vega one-piece vinyl coated gaskets. They are a bit thinner, but the correct dimensions to fit nice and tight in Cerwin Vega 12" frames. The fit is perfect, so the ends of the individual pieces abutt each other, and these have a pretty close look to the original vinyl coated gaskets you see on the older Vega woofers before they went to the plastic trim rings. These, in my opinion, look far more like original than the rubitex or chip gaskets available.  Foam dimensions. These foams are slightly different, and done that way by painstaking research and design. If you’re familiar with refoaming Cerwins, you’ve undoubtedly seen where the ID of the foam is just slightly too large, so when you’re done, you can see a little of the old glue ring inside your new foam, leaving a sloppy look. I specified these foams to be exactly a little different from the rest out there, and had them produced, from scratch, just for me, and now for you. So, these foams are not the same as any other you have ever gotten. First, if you measure the glue ring on a 12” Cerwin woofer cone, it comes in around 8 7/8. Yet, the ID of the foams everyone else sells, is generally 9”. (leaving that unsightly ring) My foams have an ID of 8 5/8, that gives you a 1/8 cushion all the way around, so when you are done, you will have a clean look. On the OD, you will also see that my foams have a larger OD, so you have more flat foam to glue to your frame. Some of the other kits are so stingy, you have just a little bit. These are wider, like Cerwin Vega originally used, although not so wide, that you run out of adjustment space when centering the cone. Then, there’s thickness. There’s a wide variance out there. These are thicker than the cheap China ones, and correct for the woofers listed. (these are different than, and not for, the clsc and xls woofers) And of course, color. Cerwin used red over gray. These are red over gray. Not paper thin like the red ones they sell from China. Not pink over gray like many sellers have. But correct thickness, RED, over gray. Glue: I’ve refoamed and reconed many hundreds of woofers over decades, and tried every glue there is. I’m including A tube of BCA3035, a fast drying clear solvent based glue that has been a favorite of speaker techs for years. I also have another clear, slower drying glue which i will include for free if you request. If you want a lot of time to make your adjustments centering the cone, this glue will give you at least half an hour. It's for foam to frame only. If you want that glue (in addition to the tube of 3035) just shoot me a nessage and I'll include that one too. Kit includes tips and tricks learned from decades of doing this myself. This kit includes two foams, and fit almost every Cerwin Vega 12” woofer made with angle attach (almost all the 12“). The exceptions are the CLSC and XLS woofers, and any woofer with a flat attach. I do have flat attach size foams in another listing. If you have any questions, don’t hesitate to reach out. These are, the absolute best kits available. You can save nine bucks, and look at glue rings and pink foams for the next 20 years, or spend the extra $9 and get the very best. If you want quantity, don’t need glue, etc, reach out. I will put together whatever kind of package you want. Will be packed securely and shipped promptly. Thanks!