BOND IT ANCHOR BOND, Resin Mortar Anchor System, GREY - 310ml

A polyester resin, 2‐part, rapid curing, chemical anchoring system. Applied in one single action to produce a cost effective, tough chemical resistant fixing.

Uses 

Suitable for setting bolts, studs, wall ties, starter bars or large screws, etc into a wide range of substrates. Compatible with brickwork, concrete, masonry, stone and PFA blocks. Hollow base materials can also be securely fastened using ANCHOR BOND in conjunction with a sleeve or sieve. Chemically resistant, waterproof and vibration proof.

Preparation 

Drill a hole to the correct diameter and depth (see chart over leaf), ideally using a rotary percussion machine. For optimum results the wall sides should be thoroughly roughened. Clean hole and remove all dust and debris using a hand air pump or a stiff rotary brush, if required. All bars should be clean and free from oil or grease and all flaking rust should be removed. Threaded rods or studs should be chisel ended to prevent them being unscrewed from the cured resin.

Application 

Screw the mixing nozzle on to the cartridge (hand tighten). Place the ANCHOR BOND cartridge into the dispensing gun. Squeeze the hand trigger a few times until material passes through the mixing nozzle. Allow the material to flow until an even colour is obtained (normally 5-6 inches). Insert the nozzle into the base of the hole and extrude material, half filling the hole with resin. Withdraw the nozzle then insert the fixing into the filled hole, slowly rotating to fully coat the surface. After application release the pressure from the dispensing gun. Remove the used mixing nozzle and wipe away excess material from the end of the cartridge. Once the resin has cured the fixture can be attached to the fixing and fully tightened. Do not over pressurise cartridge otherwise leakage may occur from rear pistons. 

Additional Information

• Curing Dependant on temperature. 
• As a guide @ 20o C:- Gel Time: 5 minutes. Full Cure: 2 hours.
• Container Size Available in 310ml 
• Colour Grey in colour. 
• Shelf Life 12 months from date of manufacture when stored in unopened cartridges. 
• Storage Conditions Store in a dry area between 5o C and 25o C. 
• Keep out of direct sunlight. Storage at higher temperatures will reduce the shelf life.

Also available: Extruder (Blue) and Anchor Bond, Grey - 400ml. Please see other listings for further information