New Arrivial
4CH Two Way Brushed ESC 2-4S 6-16V Bidirectional Electronic Speed Controller
Features:
One ESC can realize 4 independent, 1/2 mixed control, McNamee special mixed control, drive 4 motors
This top version is launched to adapt to larger voltage/current, suitable for all kinds of 6-16v, current <15A brush motor
Have a certain overload and overheat protection
Each group of motor lines directly connected to the motor, do not mix up, otherwise it will damage the ESC
Specification:
Size: 55x48mm
Parameters:
6-16.8v available 2-4S lithium (prohibit battery +- reverse connection, second burn and can not be repaired)
4 way motor output, each way long run 15A
Mute: eliminate the annoying drive noise, this noise is especially obvious when the motor is not turning or low speed (can be returned to non-mute mode through the back of the solder joint, see later description)
Fixed PWM 1500us (+50 -50) at the neutral point of the remote control, with a minimum range of 800-1100 and a maximum range of 1900-2200 automatically adapted, exceeding 800-2200 is considered an illegal signal to ignore
When inserting the receiver, yellow, 3P white, blue, gray in order to insert the receiver 1-4 channels
Power on prompt (will hear the motor "beep" a sound, prompting power on)
With neutral point start (throttle channel 1500 or so, you will hear the motor "beep", ESC start)
3, 4 way also need to stay in the neutral point first, 3, 4 way can be used separately (for safety, to prevent the power on the 3, 4 way motor on the turn)
Can set the neutral brake, mixed control, initial strength, linear parameters, where the initial strength, linear default settings to meet the newcomer, veterans see the back of the advanced parameter setting method
With runaway protection (loss of signal (in an accident, the signal line is broken), for safety, motor protection, need to throttle back to the center, re-unlock
with overheat protection (100 degrees) (such as running over the rated current, overheating motor output will stop, but if you suddenly connect more than the rated very large motor, it will also burn out)
bec output 5v max 1.5A, when the current is large, voltage regulator chip 7805 heat, pay attention to heat dissipation (Note: the on-board microcontroller is also 5V power supply <and bec connected together>, if you plug the 2S lithium <7.4V> directly into the receiver, microcontroller seconds burn <maximum withstand voltage 6.5V>)
Each group of motor lines directly connected to the motor, do not mix up, otherwise it will damage the ESC (printed on the board M1 - M4, indicating the order of the motor)
The motor output is prohibited from short-circuiting or mistakenly touching the metal short-circuit without connecting the motor (this short-circuit will burn the output in seconds, the repair is very troublesome and extremely high cost)
The factory has been sealed with heat shrink adhesive to avoid damage by accidental touching short circuit
ESC has 3 modes: (default four independent, can be set by knob)
Four-way independent: 1-4 signal lines independently control 4 motors forward and reverse respectively. If you want to use that channel to control the motor, plug that channel; or you can set the mixed control by yourself in the remote control (such as tracked vehicle mixed control)
1/2 way mixed control: 1/2 way mixed control is equivalent to a two-way mixed control ESC, plus 3,4 way two independent ESC
McNamee: the third signal wire (blue) can be left unconnected, control the omnidirectional car left and right, front and rear and head direction, control the amplitude of the lever and the combination of operations, can make more than 10 kinds of rich movements
Package:
1x ESC
