Mount a Compatible eufy Floodlight Camera on a 90° Outside Corner

This corner mount creates a dedicated rounded-square interface for compatible eufy floodlight cameras where two exterior walls meet. It fastens directly to the building corner and supports the camera through its factory mounting plate.

🌟 What This Mount Does

• Outside-corner placement: Positions the camera at a square 90° outside corner.
• Model-specific interface: The front geometry and internal bosses are designed for the confirmed eufy mounting plates listed below.
• Purpose-built support: Designed to support the compatible camera when securely installed with fasteners appropriate for the building surface.

📹 Confirmed Compatibility

• eufy Floodlight Camera E30
• eufy Floodlight Camera E340
• eufy Floodlight Camera S330

Other eufy models are not confirmed. Compare your factory mounting plate with the listing images before ordering.

🔩 Mounting Interface

• Mounts directly to a square 90° outside corner through four rear mounting holes.
• The camera's factory mounting plate attaches to the internal bosses with the four included thread-forming screws.
• Wall screws and anchors are not included; choose fasteners appropriate for the wall material and installed load.

🔌 Wiring & Moisture Management

• Three threaded 1/2-inch NPT openings accept standard electrical conduit adapters.
• Three closure plugs are included for unused openings; conduit fittings are not included.
• No gasket is included. Use the camera's gasket where provided and properly seal all installed fittings.
• An integrated drain opening allows incidental moisture to weep out. The mount is not represented as a watertight enclosure.

📦 In The Box

• 1 white eufy outside-corner mount
• 4 × #8 × 3/4-inch thread-forming screws for the factory mounting plate
• 3 closure plugs

Camera, camera mounting plate, wall fasteners, anchors, gasket, conduit fittings, conduit, and wiring are not included.

🛠️ Installation Notes

1. Turn off power and verify the circuit is de-energized.
2. Fasten the mount securely to both faces of the 90° corner using appropriate customer-supplied wall fasteners.
3. Install the required conduit fitting and close every unused NPT opening.
4. Attach the camera's factory mounting plate with the four included thread-forming screws, complete the wiring, and install the camera according to its instructions.