500K CUSTOM TAPER VOLUME POT W/HIGH PASS
FILTER
Standard guitar pots limit your
musical expression, only starting to deliver sound at about “3” on the dial and
then never getting much louder above “7”. DiMarzio’s custom taper pot is made to
solve that problem by precisely delivering the same ratio of signal-to-turn as
an actual 10-position actuator. This provides players with
audiophile-like control over dramatic volume swells and signal gain, so you can
truly use the guitar’s total range. And don’t worry about wearing these out —
each pot is rated to 10,000 cycles at 2,000 cycles per hour
and is individually tested by DiMarzio to meet our rigid
standards.
DiMarzio also understands that
a pot has to feel as good as it sounds. The tech talk is that we
engineered them with a low friction wiper pass and proprietary balance-damping
lubricant. In plain terms, that means slick pinky flips and a pot that will
still hold at any sweet spot on the dial. So, whether you
just crank the guitar to 10, dizzy your audience with violin-esque swells, or
prefer to control your gain through the guitar’s volume knob, DiMarzio’s pots
put the control back in your hands.
For the player who wants to
turn down the volume without the typical loss of high end and presence,
DiMarzio Custom Taper pots come pre-wired with a “high-pass” filter (also
known as a “treble bleed” circuit). Our parallel-wired combination of a 560 pF capacitor and 300 kOhm resistor allow the pot to
essentially maintain all of its articulation, attack, and highs, even at whisper
levels. Ideal for humbuckers or single-coils, the DiMarzio Custom Taper pot
gives players total access to their instrument’s lower ranges of gain and
intensity without compromising nuance or tone.
The split shaft and bushings
are made from machined brass, just like the vintage originals, with 24
teeth and a 32-thread turn, a perfect fit for USA knobs, including DiMarzio,
Fender®, and Gibson®. We also include two nuts, one dress washer, and a lock
washer for easy installation. All of our pot casings are
custom-plated for easy soldering.
*Please note, these are
direct replacements for the standard 3/8-inch (9.525mm) holes found on most
Fenders and Gibsons. Some enlargement may be required for non-standard or
import-specific hole diameters.
Wiring diagrams for this pot can be found on the
DiMarzio web site.
FREE EXTRAS WITH EVERY PURCHASE!!!
WE HAVE BEEN
AN AUTHORIZED DIMARZIO PICK-UP DEALER FOR OVER 25
YEARS!!!
We were a full
service guitar shop in operation for over 30 years.
We stock over 2000 + Humbucking
Pick-ups. IF YOU
WOULD LIKE TO LEARN MORE ABOUT THIS POT, OR HAVE ANY OTHER QUESTIONS ABOUT THIS
AUCTION, PLEASE, BEFORE YOU
PURCHASE, contact me
I take ALL parcels to the Post
Office personally. The pots shown (displayed) in the pictures are the actual products that are
up for sale.ALL SALES ARE
FINAL.