Specification:

Description:

• Insulation piercing connector is mainly used for wire branching , the applicable voltage is 1KV.


• Small contact resistance and low temperature rising. The specially-made moment bolt s constant piercing pressure which enable the connector to get a good electric contact without any excessive conductor damage, and the normal performance life of circuitry.

• The conductor used for insulation piercing connector must conform with international standard.


• The Installation operator must be familiar with installation technique.


• Please put on insulating gloves and use insulating box spanner during hot-line work.


• The insulation piercing connector is a kind of one-time product. Please do not use it again after dismantling because of pattern transfiguration.

• Installing and fixing main cable in traditional way.


• Stripping outer insulator of main cable for 0.6m at part that need part( do not destroy insulation layer for phase).


• Choosing branch cable (not more than) that distance is the same as electric meter box, and strip insulator at two terminals.


• Installing the separator vertically by turns( the distance is more than 10cm)

• Special for street lamp system(vertical shaft forbidden)


• For connecting the building lights, street lamp, high building vertical shaft.


• For connecting the cables of high building vertical shaft, outdoor overhead wires, cable duct, factory power cable.