MOTOR

Brushless sensor-less motor for Mini-z and any other 1/28 sized micro racers! Features large air ventilation holes to keep with keeping temperatures cool! Four different set of mounting holes allows for you to shift the wiring to allow for ease of mounting. D shaped cut motor shaft for use with both plastic and metallic pinion gears with set screws!

Feature:

For: Mini-Z and other 1/28 Scale Racers
Material: Aluminum
Color: Black/Blue
KV: 9500
Dimensions : 36mm X 15mm (w/shaft)  , 27mm X 15mm (w/o shaft)

Include:

9500KV Mini 1410 2 Poles Sensorless Brushless Motor (1 pc)

ESC

Feature:
For: Mini-Z and other 1/28 Scale Racers
Fully Programmable (programming card sold separately)
Material: Aluminum
Color: Blue
Compatible with sensorless brushless motor.
Multiple protection features: Low voltage cut- off protection for lithium or nickel battery / Over-heat protection/Throttle signal loss protection/Motor blocked protection

Specification:
Cont. Current/Burst Current: 12A / 36A
Battery: 1-2 cells lipo,3-4 cells NiMH
BEC Output: 5V /300mA(analog mode)
Dimension: 15x26x11.5mm

Include:
Mini 18A Mini ESC (1 pc)

Tech Note: If used in Mini-Z , separate Receiver is required. 

PROGRAMMING CARD

Features:

1.Initial Start Force:5%,13%,21%,32%(default value 5%).
2.Low Voltage Cut-Off: The function is mainly to prevent the lithium battery pack from over discharging. When using lithium battery pack, please set the suitable value for low-voltage protection as your like. WARNING: Never use the default value “Non-protection” for lithium battery! 3.1V.3.3V.2.9V(default value 3.1V).
3.Drag Brake Force: 100%,90%,80%,70%(default value 100%).
4.Maximum Reverse Force: 95%,75%,50%(default value 95%).
5.3 Start Modes (Also called “Punch”) from “soft” to “very aggressive” (default value Medium).

Programming Card Method:
1.Connect BEC wires with the program car then turn on the ESC.
2.The Green LED flashes for 2 times then LED off, that is, the connecting program car with ESC is successful, and the Red LED on presents the current value of that item. Otherwise, the connecting is failed.
3.Please press the Key “↓” to select different programs
4.Please press the Key “→” to select different value of the current program
5.Please press the Key “Program” to confirm above selections, the Green LED on immediately and has gone out within 5 seconds, that is, this process is successful.
6.Please press the Key “Reset” to reset the factory setting.