Premium Quick Nut Kit for Wheel Balancers Equipped w/ 36mm x 3
Non-Acme Threaded Shaft.
 
Features a premium Dual Jaw design.  2 sets of steel jaws 180 deg. apart contact the balancer shaft threads providing a greater contact area and higher clamping pressures than cheaper copies!
 
Speeds up the balancing process and saves you time!
 
Included you will receive:
 
1 Dual Jaw Quick Clamp Hub Nut w/ Handles
1 Pressure Cup
1 Pressure Cup Rubber Ring 
(to protect the wheel from scratches)
1 Pressure Ring 
(for use when front cone mounting)


 

The following models may be equipped with 36mm x 3mm threaded shaft:
 
Accuturn – 6100, 6600, 6700, 6800
Ammco – 1030
Cemb – All Models Prior to 1995 (Excludes HD Models)
Coseng / Atlas – C301, C311, C322, C366
Focus – All Models (Excludes HD Models)
Launch – 402, 412
Phoenix – CB-114
Ranger – DST1000 
RAV – All Models
Rels – R1500
Werther - All Models (Excludes HD Models)


 

IMPORTANT!
 
ANY PRODUCT FITMENT INFORMATION CONTAINED WITHIN THIS LISTING IS MEANT ONLY AS A GUIDE AND SHOULD NOT SUBSTITUTE MEASURING YOUR BALANCER SHAFT AND DETERMINING DIAMETER, PITCH, AND THREAD TYPE.  MEASURE TO BE SURE THAT THIS IS THE CORRECT SIZE FOR YOUR MACHINE.  IF YOUR BALANCER SHAFT IS ANYTHING OTHER THAN 36MM X 3MM SEND US A MESSAGE AND WE CAN HELP YOU FIND THE CORRECT PART FOR YOUR MACHINE.
 
DOES NOT Fit Wheel Balancers w/ ACME Threaded Shaft!
 
20% RESTOCKING FEE WILL BE CHARGED ON ALL RETURNS!
 
Replacement Pressure Cups, Rubber Rings, Standard Solid Hub Nuts, Balancer Cones and more available in our ebay Store!
 
 
What else can we help you find?
Visit our eBay store!

   
   
   
  Disclaimer- 
  The parts we offer are an O.E. alternative replacement; they are not produced by O.E. Manufacturers such as Accuturn, Bosch, All Tool, Ammco, Coats, FMC, John Bean, Hennessy, Hunter, Kwikway, Hofmann, Snap-On, Van Norman, or similar manufacturers respectively.