Here’s a helpful device that
enables you to securely hold, position and rotate small engines, transmissions, rear axle differentials
and other components while you’re working on them leaving both hands free for work. This holding fixture
will handle pieces weighing up to 250 lbs., and it offers 360° of
rotation with positive stops at 90° increments. Three sides of the
mounted unit remain fully exposed. The two arms on this fixture adjust to hold almost anything you can get two bolts into, holes on end of the arms 3/8" diameter. Shaft size is 1 1/2" in diameter. Base will fit most other transmission holding fixtures, hole size is 1 5/8".
Features:
Bench Mounts w/ included base
Full 360 degree swing
Will handle engines, transmissions and other components weighing up to 250 lbs.
All Steel Construction with steel arms
Allows work comfort at any angle
Allows easy access to work on valve body
Similar to OTC 7020 , Ford Motorcraft P/N: 307-003 / T57L-500-B and Atec Trans-Tool T-0156-A
For use on these Transmissions:
Ford C4, C5, C6, AOD, AOD-E, AOD-EW (4R70W), AXOD, AXOD-E (AX45) (AX4N)
Chrysler 904 (30RH), 998 (31RR), 999 (32RH)