10SI 12SI 13.8 volt 1 wire regulator & brush set

NEW conversion kit for Delco 10SI & 12SI alternators. This kit includes the new parts as shown in the picture. A Complete brush set, with springs & a retaining pin, and a self-exciting 12-volt voltage regulator. This regulator has a LOW voltage Set Point of 13.8 Volts.  If you have any questions, feel free to ask.

Note;  A 1 wire configuration IS NOT recommended for low RPM engines.
The engine must be revved up once at start up to excite the alternator. The RPM needed to turn the alternator on will depend on the overall condition of the alternator, How well the rotor and stator are matched to each other, and Pulley sizes.

Note;  This regulator can be used for 1 wire or 3 wire wiring configurations.

Once the alternator is complete and installed on the vehicle you may need to excite the alternator for the first time. 
HOW TO EXCITE A 1 WIRE ALTERNATOR to excite the One-Wire (Self Exciting) alternator you run a jumper from the post (positive power) to the #1 spade terminal on the alternator. With the motor running, you momentarily touch the jumper from the case to the #1 terminal, and then the alternator should start charging. After you have run the vehicle for a bit at above idle speed the voltage should build to the regulators set point. You can touch the jumper between both the #1& #2 terminals. Once you excited the alternator, you should be able to turn the motor off then restart and rev the motor and the alternator will start charging.

If you have any questions, feel free to ask.
All items are in stock & ready to ship. Items ship out the same or the following business day.
All customers will receive a USPS tracking number.