FOR SALE .. "BRAND NEW" 100% USA Made GENERATOR ... SHIPPED with "HARD to FIND" .. "CORRECT" PARTS (as shown in Pictures) ...  ( NEW Generator GEAR, Oil SINGER, Heavy Duty GASKET, WASHER and NUT )

Fits: 1936 thru 1957 Big Twin  PRE - 1958  with  STOCK 1/4" mounting bolts ....   with "Additional" PARTS SHOWN in PICTURES 

this is a:    100% ... MADE in the USA  -  DGV-5000LH ...  "Special"  12 volt generator with built-In Solid State Regulator      

 Black Finish  .. OR .. Milled Housing .. (depending upon current stock) ..... 

 *** This is the "SPECIAL APPLICATION" Generator used with 1/4" Mounting Bolts .. as used in 1957 and earlier Big Twin applications 

 NOTE:  ..  this 'Special DGV-5000LH'  12 volt Generator is made  so you can use oem type pre 1958  1/4" mount bolts ... NO Need to Drill Out Your Stock Harley Cases ... this "SPECIAL GENERATOR" will bolt right up   .. and ..  ALSO,  on pre 1958 models,  use 31035-58 oil deflector, discard spring and old deflector ...   (WE SELL these Parts too!) ... 7.58 inches is overall length from gasket surface to tip of fins on these Generators ... check for clearance on foot clutch models ........

*** BRAND NEW !  with Factory WARRANTY ***

FOR SALE .. Fits:  Big Twin  PRE - 1958 with STOCK 1/4" mounting bolts ....   

===========================================

Note:  "Upon Request:  we also sell (looks same as above)  generator in CORRECT amperage  for electic start models with 19 through 28 amp batteries.   ... when replacing 65B generator (82-84 Hitachi) you'll need 31035-58 oil deflector ... (we SELL this Part too!)

--------------------------------------------------------------------------------------------------------------------------------------------

Note: "Upon Request"... we also sell (looks same as above)  in a  'LOW Amperage'  12-volt generator for kick start only models with 5.5 amp battery.    (this is 12volt model # 17073)   This  'LOW Amperage'  generator can also be used to update 1958 thru 1964 6 volt systems to 12 volt ... and 1936 thru 1957  ...  on pre 1958 models case must be drilled to accept 5/16" mount bolts .. and .. use 31035-58 oil deflector, discard spring and old deflector ...  7.58 inches is overall length from gasket surface to tip of fins on these Generators ... check for clearance on foot clutch models ....    (we SELL these Parts too!) 

NOTE:  .. "Upon request"    CONTACT Paul about additional PARTS ... like:  1/4" mount bolts 'additional cost' .. OR .. 5/16" mounting bolts .. OR .. HEAVY DUTY Gaskets  .. OR .. Oil Deflector .. OR .. GEAR for Generator

..  NOTE:   on pre 1958 models,  use 31035-58 oil deflector, discard spring and old deflector ...   (WE SELL these Parts too!) ... 7.58 inches is overall length from gasket surface to tip of fins on these Generators ... check for clearance on foot clutch models ........

NOTE:  * * *  QUESTIONS? ... Please contact Paul before Buying to make sure! * * *  THANK YOU!   ...

We have LOTS of PARTS! ...  

(Itemt32-0212#293)(LV,t32-9000#290)(ce#260)

(item6/t32-9001)(ce#256)(t#oild#6)

(CE-#385 .. (11,20,23)